CCNA PRACTICE | COMPLETE PRACTICE QUESTIONS, ANSWERS &
STUDY GUIDE 2026/2027 Already Graded A+
What are the steps to configure a static route - (ANSWER)Configure unidirectional static routes to and
from a stub network
Define a path to the IP destination network
Question: Which of the following commands will display information about the specific port channel
interface? - (ANSWER)show etherchannel port-channel
show etherchannel port-channel - (ANSWER)Use the [show vlan] command to verify that the port is in
the correct VLAN
Use the [show mac address-table] command to check which addresses were learned on a particular port
and which VLAN that port is assigned
You are troubleshooting a connectivity issue on the Branch router when you realize that a ping test to
the destination network is not successful. The Branch and corresponding HQ router have their neighbor
adjacency set up. What could be the problem? - (ANSWER)The HQ router isn't advertising the route
There is a route missing to the destination in the Branch router`s routing table
A user is experiencing a loss of end-to-end connectivity in an IPv4 network. You have verified that there
is no physical connectivity issue. Logically, what should you check next? - (ANSWER)Whether the current
path is undesirable
Which statements describe a trunk operation? - (ANSWER)It's the link between an Ethernet switch
interface and a router
Cisco supports the 802.1 Q trunking protocol
You are tasked with configuring a switch so that it can be accessed remotely. What do you need to
configure in order to accomplish this? - (ANSWER)An IP address and subnet mask
A default gateway
STUDY GUIDE 2026/2027 Already Graded A+
What are the steps to configure a static route - (ANSWER)Configure unidirectional static routes to and
from a stub network
Define a path to the IP destination network
Question: Which of the following commands will display information about the specific port channel
interface? - (ANSWER)show etherchannel port-channel
show etherchannel port-channel - (ANSWER)Use the [show vlan] command to verify that the port is in
the correct VLAN
Use the [show mac address-table] command to check which addresses were learned on a particular port
and which VLAN that port is assigned
You are troubleshooting a connectivity issue on the Branch router when you realize that a ping test to
the destination network is not successful. The Branch and corresponding HQ router have their neighbor
adjacency set up. What could be the problem? - (ANSWER)The HQ router isn't advertising the route
There is a route missing to the destination in the Branch router`s routing table
A user is experiencing a loss of end-to-end connectivity in an IPv4 network. You have verified that there
is no physical connectivity issue. Logically, what should you check next? - (ANSWER)Whether the current
path is undesirable
Which statements describe a trunk operation? - (ANSWER)It's the link between an Ethernet switch
interface and a router
Cisco supports the 802.1 Q trunking protocol
You are tasked with configuring a switch so that it can be accessed remotely. What do you need to
configure in order to accomplish this? - (ANSWER)An IP address and subnet mask
A default gateway
