AET NCATT Questions with CORRECT Answers
Question:
Should not exceed 2% of the regulated voltage when the generator is carrying rated
current or the battery is being discharged at 5 minute rate.
Answer:
Voltage drop in wires (5.5.5.1)
Question:
The allowable voltage drop in a 28 volt continuous circuit is:
a. 1 volt
b. 2 volts
c. 5 volts
d. 4 volts
Answer:
a. 1 volt
Question:
Suspected Unapproved Parts (SUP) - Red Tagged - Placed in quarantine
Answer:
report using FAA Form 8120-11. Ref. AC 21-29.
Question:
Record Keeping
Answer:
The Work Order Form
Question:
Amended Equipment List Service Bulletins and/or AD compliance sheets Copies of
manufacturers technical data Function test and/or calibration results Configuration data
Component traveler Copies of Return to Service documents Return to Service of an
article after maintenance/ alteration will include:
Answer:
Log book entry
, Question:
FAA Form 337 for major repair or alteration Amended Equipment List calibrated
equipment
Answer:
check that test equipment has current calibration label attached,
Question:
NAS
Answer:
National Aircraft Standard
Question:
What prevents RFI?
Answer:
Grounding and bonding
Question:
BONDING JUMPER length
Answer:
Bonding jumpers should be kept as short as practicable, and installed so that the
resistance of each connection does not exceed 0.003 ohm. The jumper should not
interfere with the operation of movable aircraft elements, such as surface controls;
normal movement of these elements should not result in damage to the bonding
jumper.
Question:
Bonding and grounding surface prep
Answer:
To be sure a low resistance connection has been made, nonconducting finishes, such as
paint and anodizing films, should be removed from the surface to be contacted by the
bonding terminal.
Question:
Should not exceed 2% of the regulated voltage when the generator is carrying rated
current or the battery is being discharged at 5 minute rate.
Answer:
Voltage drop in wires (5.5.5.1)
Question:
The allowable voltage drop in a 28 volt continuous circuit is:
a. 1 volt
b. 2 volts
c. 5 volts
d. 4 volts
Answer:
a. 1 volt
Question:
Suspected Unapproved Parts (SUP) - Red Tagged - Placed in quarantine
Answer:
report using FAA Form 8120-11. Ref. AC 21-29.
Question:
Record Keeping
Answer:
The Work Order Form
Question:
Amended Equipment List Service Bulletins and/or AD compliance sheets Copies of
manufacturers technical data Function test and/or calibration results Configuration data
Component traveler Copies of Return to Service documents Return to Service of an
article after maintenance/ alteration will include:
Answer:
Log book entry
, Question:
FAA Form 337 for major repair or alteration Amended Equipment List calibrated
equipment
Answer:
check that test equipment has current calibration label attached,
Question:
NAS
Answer:
National Aircraft Standard
Question:
What prevents RFI?
Answer:
Grounding and bonding
Question:
BONDING JUMPER length
Answer:
Bonding jumpers should be kept as short as practicable, and installed so that the
resistance of each connection does not exceed 0.003 ohm. The jumper should not
interfere with the operation of movable aircraft elements, such as surface controls;
normal movement of these elements should not result in damage to the bonding
jumper.
Question:
Bonding and grounding surface prep
Answer:
To be sure a low resistance connection has been made, nonconducting finishes, such as
paint and anodizing films, should be removed from the surface to be contacted by the
bonding terminal.
