NCCCO PT EXAM 2026/2027 UPDATED VERIFIED
QUESTIONS AND SOLUTIONS A+ PASS
GUARANTEED|COMPLETE STUDY GUIDE WITH 100%
ACCURATE QUESTIONS &ANSWERS. EXCELLENCE
GUARANTEED.
Which unsafe condition could result when a wedge socket is attached directly to a load hook,
using 6x19 IWRC?
(A) Spinning of the load (B) Decreased line pull (C) Decreased safe working load (D) Structural
failure Answer: (A) Spinning of the load
Which if the following will indicates intemal damage or ultimately core failure in rotation-
resistant rope?
(A) Strand bird caging (B) Dianeter reduction (C) Excessive lubrication (D) Kinking Answer: (B)
Dianeter reduction
When a jib is erected from the stowed position and not used, how will its effective weight
change?
(A) It decreases (B) It increases (C) It will tip the crane (D) It stays the same Answer: (B) It
increases
(45.When operating a telescopic boom crane equipped with an anti two-block prevention
device, which hydraulic functions are disabled when the device is activated? (A) Winch down,
boom up, and retract the boom. (B) Swing, Winch down, and raise the boom. (C) Hoist, extend
the boom, and lower the boom. (D) Outrigger controls, retract the boom, and swing. Answer:
(C) Hoist, extend the boom, and lower the boom.
1
APPHIA - Crafted with Care and Precision for Academic Excellence.
, 46. A load applied at an angle to the vertical plane of the boom describes: (A) Over loading (B)
Side loading (C) Static loading (D) Angle loading Answer: (B) Side loading
48. Hand signals must be posted conspicuously: (A) In the vicinity of hoisting operations B. In
the drivers cab of the crane (C) In the office. (D) In the load chart Answer: (A) In the vicinity of
hoisting operations
Which crane hand signal is illustrated? (A) Retract the boom (B) Raise the boom (C) Extend the
boom (D) Lower the boom Answer: (C) Extend the boom the
Power lines would be a big concern when considering a crane's set up location, another big
concern could be? (A) Radio communication with signal person (B) Capacity of the crane (C)
Gang members, crack heads, & tweakers (D) Voids, tanks, loose fill, & depressions Answer: (D)
Voids, tanks, loose fill, & depressions
43. When inspecting the boom on a telescopic boom crane which item should be inspected? (A)
Float pads (B) Wear pads (C) Counterweight (D) Load block sheaves Answer: (B) Wear pads
Counterweight
(A) when it's reeved over the main boom tip (B) when it's reeved over the auxiliary boom head
(C) when it's on top of the boom (D) when it's reeved over the jib Answer: C
45. When a crane operator leaves the crane, the operator must first: (A) Disengage the PTO (B)
Tum the engine off (C) Land all suspended loads (D) Secure the area and lock out the controls.
Answer: C
46. Cranes operating with long booms should be most concerned with winds coming from the:
(A) Rear of the boom (B) Side of the Boom (C) East (D) South. Answer: (B)
47. According to OSHA 1926 Subpart CC which of the following is prohibited with wire rope on a
crane? (A) Splicing (B) Cutting (C) Severing (D) Lubricating Answer: (A)
2
APPHIA - Crafted with Care and Precision for Academic Excellence.
QUESTIONS AND SOLUTIONS A+ PASS
GUARANTEED|COMPLETE STUDY GUIDE WITH 100%
ACCURATE QUESTIONS &ANSWERS. EXCELLENCE
GUARANTEED.
Which unsafe condition could result when a wedge socket is attached directly to a load hook,
using 6x19 IWRC?
(A) Spinning of the load (B) Decreased line pull (C) Decreased safe working load (D) Structural
failure Answer: (A) Spinning of the load
Which if the following will indicates intemal damage or ultimately core failure in rotation-
resistant rope?
(A) Strand bird caging (B) Dianeter reduction (C) Excessive lubrication (D) Kinking Answer: (B)
Dianeter reduction
When a jib is erected from the stowed position and not used, how will its effective weight
change?
(A) It decreases (B) It increases (C) It will tip the crane (D) It stays the same Answer: (B) It
increases
(45.When operating a telescopic boom crane equipped with an anti two-block prevention
device, which hydraulic functions are disabled when the device is activated? (A) Winch down,
boom up, and retract the boom. (B) Swing, Winch down, and raise the boom. (C) Hoist, extend
the boom, and lower the boom. (D) Outrigger controls, retract the boom, and swing. Answer:
(C) Hoist, extend the boom, and lower the boom.
1
APPHIA - Crafted with Care and Precision for Academic Excellence.
, 46. A load applied at an angle to the vertical plane of the boom describes: (A) Over loading (B)
Side loading (C) Static loading (D) Angle loading Answer: (B) Side loading
48. Hand signals must be posted conspicuously: (A) In the vicinity of hoisting operations B. In
the drivers cab of the crane (C) In the office. (D) In the load chart Answer: (A) In the vicinity of
hoisting operations
Which crane hand signal is illustrated? (A) Retract the boom (B) Raise the boom (C) Extend the
boom (D) Lower the boom Answer: (C) Extend the boom the
Power lines would be a big concern when considering a crane's set up location, another big
concern could be? (A) Radio communication with signal person (B) Capacity of the crane (C)
Gang members, crack heads, & tweakers (D) Voids, tanks, loose fill, & depressions Answer: (D)
Voids, tanks, loose fill, & depressions
43. When inspecting the boom on a telescopic boom crane which item should be inspected? (A)
Float pads (B) Wear pads (C) Counterweight (D) Load block sheaves Answer: (B) Wear pads
Counterweight
(A) when it's reeved over the main boom tip (B) when it's reeved over the auxiliary boom head
(C) when it's on top of the boom (D) when it's reeved over the jib Answer: C
45. When a crane operator leaves the crane, the operator must first: (A) Disengage the PTO (B)
Tum the engine off (C) Land all suspended loads (D) Secure the area and lock out the controls.
Answer: C
46. Cranes operating with long booms should be most concerned with winds coming from the:
(A) Rear of the boom (B) Side of the Boom (C) East (D) South. Answer: (B)
47. According to OSHA 1926 Subpart CC which of the following is prohibited with wire rope on a
crane? (A) Splicing (B) Cutting (C) Severing (D) Lubricating Answer: (A)
2
APPHIA - Crafted with Care and Precision for Academic Excellence.
