Week 4 Quiz BBS 200 Advanced Ballistics Questions And Answers Rated A+ New Update Assured Satisfaction

Which is typically the first step in reloading in which a die is used? No answers are correct. Correct! Resizing the case to a reusable state Polishing the case Filling the case with primer Your answer is correct.  1 of 4 07/10/2024, 8:43 am Week 4 Quiz: BBS 200 Advanced Ballistics 241007-CB8 47033 Question 2 1 / 1 pts Quiz submitted  What must be done after any trimming operation? No answers are correct. Lubricating the case Correct! Deburring the inside and outside of the neck with a chamfering tool Removing the expander die Your answer is correct.  Question 3 1 / 1 pts What will using the dial or electronic caliper and measuring the case from the meplat to the flat of the case head where the primer is located do? Correct! It will give you the COL measurement of the loaded round after soft-seating It will give you the COL measurement of the loaded round before soft-seating There is no need to take such a measurement Help you decide whether you need to use a roll crimp instead of a taper crimp Your answer is correct.  Question 4 1 / 1 pts Achieving the proper COL for the combination of bullet, case, primer, and powder specified in the data manual will ensure safety, accuracy, and proper function. Correct!  True False Question 5 1 / 1 pts Which of the following allows great precision in your powder loading? A powder funnel A plastic spoon Power horn 2 of 4 07/10/2024, 8:43 am Week 4 Quiz: BBS 200 Advanced Ballistics 241007-CB8 47033 Correct! A powder tri Quiz submitted ckler  Your answer is correct.  Question 6 1 / 1 pts For most presses with the priming feature, which way should the primer anvil be facing? It should be facing down Correct! It should be facing up No answers are correct. It should be facing you Your answer is correct.  Question 7 1 / 1 pts After trimming, priming, and loaded the case with powder, what is now needed in your press? No answers are correct. The decapping pin Correct! The seating die The anvil Your answer is correct.