AZ ROC TRADE EXAM B-3 LICENSE EXAM WITH
CORRECT ACTUAL QUESTIONS AND
CORRECTLY WELL DEFINED ANSWERS LATEST
ALREADY GRADED A+
Save
Terms in this set (279)
Nails used for installing Hardboard 1-1/2 inches
panel siding vertically must
accommodate the sheathing and
penetrate the framing a minimum of
how much?
When framing openings in floors 4 feet
with a header and trimmer joists,
what maximum header joist span is
allowed with a single member
header?
Above the handrail and below the 36 inches
head, what is the minimum clear
opening on a stairwell?
, When installing vinyl siding, how 1 inch
much overlap should you allow for
thermal expansion?
What is the first step you should Read the manufacturers use instructions.
take when applying specialty
finishes?
What is the appropriate gap 1/4 inch
between gypsum board and a tub
surround?
Sprayed fire resistant materials are Density.
identified by ____________ and thickness
required for a given rating.
What is the most important factor in Density.
determining the "R" value of blown
in insulation?
Refer to the illustration of a 2 story 30 feet 6 inches and 13 feet 5 inches.
house w/ lap siding plans,
(complete set of plans at the test
center), What are the lengths of the
second floor trusses?
Refer tot the illustration of a 2 story inches.
house w/ lap siding plans,
(complete set of plans at the test
center), what is the height of the
foyer in inches?
CORRECT ACTUAL QUESTIONS AND
CORRECTLY WELL DEFINED ANSWERS LATEST
ALREADY GRADED A+
Save
Terms in this set (279)
Nails used for installing Hardboard 1-1/2 inches
panel siding vertically must
accommodate the sheathing and
penetrate the framing a minimum of
how much?
When framing openings in floors 4 feet
with a header and trimmer joists,
what maximum header joist span is
allowed with a single member
header?
Above the handrail and below the 36 inches
head, what is the minimum clear
opening on a stairwell?
, When installing vinyl siding, how 1 inch
much overlap should you allow for
thermal expansion?
What is the first step you should Read the manufacturers use instructions.
take when applying specialty
finishes?
What is the appropriate gap 1/4 inch
between gypsum board and a tub
surround?
Sprayed fire resistant materials are Density.
identified by ____________ and thickness
required for a given rating.
What is the most important factor in Density.
determining the "R" value of blown
in insulation?
Refer to the illustration of a 2 story 30 feet 6 inches and 13 feet 5 inches.
house w/ lap siding plans,
(complete set of plans at the test
center), What are the lengths of the
second floor trusses?
Refer tot the illustration of a 2 story inches.
house w/ lap siding plans,
(complete set of plans at the test
center), what is the height of the
foyer in inches?
