Low pressure boiler black seal || Acknowledged Answers 100%.
Where on the Certificate of Inspection would you find the State of New Jersey jurisdiction
number? correct answers upper left corner
Which of the following best describes the combustion chamber of a serpentine tube heating
boiler? correct answers it is located below the tubes
By N.J.A.C. rules, a school with a boiler plant with a total interconnected capacity of 100 BHP
would require a properly licensed operator to be present whenever the building was deemed
occupied. correct answers false
Which of the following is not a classification of a hot water system? correct answers a Hartford
loop system
When bringing a steam heating plant on line from a cold start, when the ambient conditions are
about 20 degrees F, what condition are you preventing when the pressure is increased gradually?
correct answers thermal shock
A boiler operator's log shall be maintained in each plant containing over: correct answers 100
Boiler HP
By definition, a boiler is an open vessel in which water is turned to steam under pressure by the
application of heat. correct answers false
According to state boiler regulations, where should the boiler registration number be located?
correct answers on the front of the boiler
As an operator in a plant you must always be aware of your surroundings. Which of the
following, that should be under the control of the licensed operator, can be extremely dangerous
, and cause a catastrophic hazardous event if it is not inspected annually? correct answers The
boiler(s) can be dangerous if not inspected and maintained properly
The primary purpose of establishing a set of plant safety rules is to: correct answers protect
workers and equipment
The ASME Code states that the setting on the high limit pressure control on a low pressure steam
boiler shall not exceed: correct answers 15 psig
In order to be a good operator one must have basic knowledge on the principles of how energy
works in a steam and hot water system. Which of the statements below is correct? correct
answers in a heating system, in order to change state from a liquid to a gaseous state heat must be
added.
What ASME code section is used for the care and operation of heating boilers? correct answers
ASME Code, Section VI
In a hot water heating system, where would you find an expansion tank and what is its function?
correct answers on the suction side of the pump to avoid negative pressure in the system
What is the official ASME letter stamp used to denote low pressure heating boilers? correct
answers H
What is the maximum penalty for performing the duties of a boiler operator with an expired
license? correct answers $5,000.00
What is the purpose of an aquastat control device on a boiler system? correct answers it is used
to control water temperature
In a two-pipe direct-return hot water heating system, the supply and return water flow in the
same direction. correct answers false
Where on the Certificate of Inspection would you find the State of New Jersey jurisdiction
number? correct answers upper left corner
Which of the following best describes the combustion chamber of a serpentine tube heating
boiler? correct answers it is located below the tubes
By N.J.A.C. rules, a school with a boiler plant with a total interconnected capacity of 100 BHP
would require a properly licensed operator to be present whenever the building was deemed
occupied. correct answers false
Which of the following is not a classification of a hot water system? correct answers a Hartford
loop system
When bringing a steam heating plant on line from a cold start, when the ambient conditions are
about 20 degrees F, what condition are you preventing when the pressure is increased gradually?
correct answers thermal shock
A boiler operator's log shall be maintained in each plant containing over: correct answers 100
Boiler HP
By definition, a boiler is an open vessel in which water is turned to steam under pressure by the
application of heat. correct answers false
According to state boiler regulations, where should the boiler registration number be located?
correct answers on the front of the boiler
As an operator in a plant you must always be aware of your surroundings. Which of the
following, that should be under the control of the licensed operator, can be extremely dangerous
, and cause a catastrophic hazardous event if it is not inspected annually? correct answers The
boiler(s) can be dangerous if not inspected and maintained properly
The primary purpose of establishing a set of plant safety rules is to: correct answers protect
workers and equipment
The ASME Code states that the setting on the high limit pressure control on a low pressure steam
boiler shall not exceed: correct answers 15 psig
In order to be a good operator one must have basic knowledge on the principles of how energy
works in a steam and hot water system. Which of the statements below is correct? correct
answers in a heating system, in order to change state from a liquid to a gaseous state heat must be
added.
What ASME code section is used for the care and operation of heating boilers? correct answers
ASME Code, Section VI
In a hot water heating system, where would you find an expansion tank and what is its function?
correct answers on the suction side of the pump to avoid negative pressure in the system
What is the official ASME letter stamp used to denote low pressure heating boilers? correct
answers H
What is the maximum penalty for performing the duties of a boiler operator with an expired
license? correct answers $5,000.00
What is the purpose of an aquastat control device on a boiler system? correct answers it is used
to control water temperature
In a two-pipe direct-return hot water heating system, the supply and return water flow in the
same direction. correct answers false
