ECC Test 4 with 100% Correct
Answers
circuit - ANS-Types of alarm signals and their locations depend on the ______ on which
they are used.
Electronic Signal Unit - ANS-Principal types of audible signals are bells, buzzers, horns,
sirens, and ______.
Chief Engineer (Chain of command) - ANS-Prior to shutdown of an ICSM alarm panels,
authorization must be obtained from the ______.
control - ANS-Power distribution, 60 Hz Ship's Service Generating Plant consist of 3
Ship's Service Gas Turbine Generator sets, with 3 Ship's Service Generator Control
Switchboards 1SG, 2SG, 3SG local plant ______.
boundaries - ANS-The ship is divided into several vertical zones using main subdivision
bulkheads as ______.
Load Center - ANS-Each zone has at least one port and one starboard ______
connected to the respective bus.
75 feet - ANS-How long can the portable flexible cable jumpers, which are provided for
connecting riser terminals to horizontal bulkhead terminals, be?
Bus Ties - ANS-Switchboard 2SP provides Shore Power and the means to power loads
distributed from the other two Switchboards via ______.
damage - ANS-Safety precautions for Shipboard Lining System Operation must always
be taken when working around electrical equipment and circuits to avoid injury,
possibility of death, and equipment ______.
impairment - ANS-The person going from a brightly lighted area to a darkened area
suffers from an immediate ______ of vision.
Light Security - ANS-The use of light traps, door operating switches, darkening the ship
control circuits and material is classification of ______.
5 hours - ANS-A battery powered lighting system provides a continuous illumination for
a minimum of ______ for personal evacuation, and control and operation of the ship.
, transformer - ANS-Each lighting Automatic Bus Transfer provides power from 450 Volts
to 120 Volts step down lighting ______.
evaluated - ANS-Shipboard fatalities have been reported due to contact with 115 Volts
circuits, but all voltages present a risk that must be ______.
alone - ANS-Never work on energized electronic equipment when ______.
Arc Flash rated - ANS-When repair or maintenance must be done on energized circuits
or equipment, a protected ______ coat overalls, hood, and or coveralls must be worn.
300 Volts - ANS-A non-conducting safety line or equivalent shall be attached to the
safety harness or tied around the upper body for work greater than ______.
evolution - ANS-Electrical safety is an all-hands ______.
circuit breaker - ANS-Each Shore Power Feeder is protected at the Ship's Service
Switchboard 2SP by a ______.
closed - ANS-A blue light at the breaker illuminates only when the breaker is ______.
open - ANS-A yellow light at the breaker illuminates only when the breaker is ______.
12 - ANS-How many motor operated circuit breakers are housed by the 2SP
Switchboard?
short circuit - ANS-Electronic short circuit trip device is set at 6300 Amps and trips
instantaneously on ______.
To protect Shipboard systems from damage. - ANS-Why do circuit breakers trip?
Systems used for propelling the ship out of danger. - ANS-Which ship action would
require the use of temporary power connection Casualty Power System?
Switchboard. - ANS-At which location are Casualty Terminals located?
450 Volts. - ANS-How many Volts AC is available for Casualty Power during emergency
situations?
4 feet 6 inches. - ANS-What is the minimum height above deck level that the Bulkhead
Terminal is installed?
When normal source voltage drops below the normal rated voltage. - ANS-When, during
a normal source failure, does the Automatic Bus Transfer Switch transfers a load from a
Normal source to the Emergency source?
Answers
circuit - ANS-Types of alarm signals and their locations depend on the ______ on which
they are used.
Electronic Signal Unit - ANS-Principal types of audible signals are bells, buzzers, horns,
sirens, and ______.
Chief Engineer (Chain of command) - ANS-Prior to shutdown of an ICSM alarm panels,
authorization must be obtained from the ______.
control - ANS-Power distribution, 60 Hz Ship's Service Generating Plant consist of 3
Ship's Service Gas Turbine Generator sets, with 3 Ship's Service Generator Control
Switchboards 1SG, 2SG, 3SG local plant ______.
boundaries - ANS-The ship is divided into several vertical zones using main subdivision
bulkheads as ______.
Load Center - ANS-Each zone has at least one port and one starboard ______
connected to the respective bus.
75 feet - ANS-How long can the portable flexible cable jumpers, which are provided for
connecting riser terminals to horizontal bulkhead terminals, be?
Bus Ties - ANS-Switchboard 2SP provides Shore Power and the means to power loads
distributed from the other two Switchboards via ______.
damage - ANS-Safety precautions for Shipboard Lining System Operation must always
be taken when working around electrical equipment and circuits to avoid injury,
possibility of death, and equipment ______.
impairment - ANS-The person going from a brightly lighted area to a darkened area
suffers from an immediate ______ of vision.
Light Security - ANS-The use of light traps, door operating switches, darkening the ship
control circuits and material is classification of ______.
5 hours - ANS-A battery powered lighting system provides a continuous illumination for
a minimum of ______ for personal evacuation, and control and operation of the ship.
, transformer - ANS-Each lighting Automatic Bus Transfer provides power from 450 Volts
to 120 Volts step down lighting ______.
evaluated - ANS-Shipboard fatalities have been reported due to contact with 115 Volts
circuits, but all voltages present a risk that must be ______.
alone - ANS-Never work on energized electronic equipment when ______.
Arc Flash rated - ANS-When repair or maintenance must be done on energized circuits
or equipment, a protected ______ coat overalls, hood, and or coveralls must be worn.
300 Volts - ANS-A non-conducting safety line or equivalent shall be attached to the
safety harness or tied around the upper body for work greater than ______.
evolution - ANS-Electrical safety is an all-hands ______.
circuit breaker - ANS-Each Shore Power Feeder is protected at the Ship's Service
Switchboard 2SP by a ______.
closed - ANS-A blue light at the breaker illuminates only when the breaker is ______.
open - ANS-A yellow light at the breaker illuminates only when the breaker is ______.
12 - ANS-How many motor operated circuit breakers are housed by the 2SP
Switchboard?
short circuit - ANS-Electronic short circuit trip device is set at 6300 Amps and trips
instantaneously on ______.
To protect Shipboard systems from damage. - ANS-Why do circuit breakers trip?
Systems used for propelling the ship out of danger. - ANS-Which ship action would
require the use of temporary power connection Casualty Power System?
Switchboard. - ANS-At which location are Casualty Terminals located?
450 Volts. - ANS-How many Volts AC is available for Casualty Power during emergency
situations?
4 feet 6 inches. - ANS-What is the minimum height above deck level that the Bulkhead
Terminal is installed?
When normal source voltage drops below the normal rated voltage. - ANS-When, during
a normal source failure, does the Automatic Bus Transfer Switch transfers a load from a
Normal source to the Emergency source?
