Class notes Electrical Engineering (EDS)

A short ispLever Tutorial
Follow the following steps closely and make sure you understand the process.
Open ISPLever
File >> New Project
Type: “ass1” or any name of your choice
NEVER PUT SPACES OR OTHER CHARACTERS IN FILENAMES!!!!!
Change Project Type to Schematic/ABEL
Save in: Locate your memory stick and folder
Click OK

Right click on the Chip Symbol >> Select New Device
Change the following:
Family: GAL Device (Scroll up)
Device: GAL16V8D
Part name: GAL16V8D-25LP (Scroll)
Click OK

Right click on the Chip Symbol >> Click on New
Choose Schematic >> Click OK
Type: “ass1” or any name of your choice

Transfer your design to the schematic
Save your schematic




Go back to ispLever Project Navigator and Select the Chip symbol and double click on
Chip report as shown below

, To simulate your design you need to create waveform

Right click on the Chip Symbol >> Click on New
Choose Waveform Stimulus >> Click OK
Choose ass1 >> Click OK
Type: “ass1” or any name of your choice

Go to Edit >> Import wave
Click on Add All
Click on Show




Click on Cancel