NICET LEVEL 1 UPDATED EXAM PAPER
QUESTIONS AND ANSWERS SURE A+
✔✔Building Owner - ✔✔software information and as built drawing shall be maintained
for the life of the system by which of the following?
✔✔2.54 ohms - ✔✔what is the wire resistance in ohms of 500 feets of 16 awg solid
copper which is coated at 75 degrees C?
✔✔indirect pressure - ✔✔which of the following concerns the use of pressure points in
the body to help control bleeding?
✔✔3 feets - ✔✔Each EMT run between termination points shall be securely fastened
within _______feets of each outlet box, junction box, device box ,cabinet , conduit body,
or other tubing termination ?
✔✔5 telephones - ✔✔two way shall be tele capable of permitting the simultaneous
operation of any ______telephone stationsin a commun talked mode
✔✔13 wires of 12 AWG - ✔✔Consider a 4x4 Square electrical box that is 2 1/8" deep.
what is the maximum number of 12 AWG conductor which can be used?
✔✔10 feets - ✔✔EMT shall be security fastener in place at least every____feets
, ✔✔Maintained in safe condition - ✔✔all hand and power tools,whether furnished by
employee or employer, shall be?
✔✔Very Extra High - ✔✔A green color code green indication on a heat detector
indicates what operating temperature classification ?
✔✔4.04 ohms - ✔✔What is the wire resistance in ohm of 500 feet of 18 AWG solid
copper which is a coated at 75 degrees C?
✔✔96" AFF and a least 6" below the ceiling - ✔✔what is the appropriate mounting high
for audible notification appliance?
✔✔listed - ✔✔A multi criteria device shall be ____ for the primary function of the device
✔✔15% - ✔✔Spaces separated by a partition shall be considered as separate room for
projected beam smoke detectors when the partition extend to within what percentage of
the ceiling high?
✔✔Soft tissue injuries - ✔✔which of the following is caused by muscle pains and
spams?
✔✔3.19 ohm - ✔✔what is the wire resistance in ohms, of 1000 feet of 14 AWG solid
copper which is coated at 75 degrees C?
✔✔200 seconds - ✔✔a trouble signal shall be indicated and recorded
with____seconds?
✔✔Shunt - ✔✔What type of auxiliary fire alarm system does not permit the use of
automatic detectors?
✔✔110 % - ✔✔A steam pressure supervisory shall indicate a low pressure condition
.The off normal signal be initiated prior to the pressure falling below _____% of the
minimum operating equipment supplied?
✔✔7 AMP - ✔✔A non power limited fire alarm circuit which 18 AWG shall have over
current protection not to exceed ___ amperes?
✔✔The system designer - ✔✔the features for non required system shall be established
by _____ on the basis of the goals and objectives of the building owner ?
✔✔8.08 ohm - ✔✔What is the resistance in ohms, of 1000 feet of 18 AWG solid copper
which is coated at 75 degrees C?
QUESTIONS AND ANSWERS SURE A+
✔✔Building Owner - ✔✔software information and as built drawing shall be maintained
for the life of the system by which of the following?
✔✔2.54 ohms - ✔✔what is the wire resistance in ohms of 500 feets of 16 awg solid
copper which is coated at 75 degrees C?
✔✔indirect pressure - ✔✔which of the following concerns the use of pressure points in
the body to help control bleeding?
✔✔3 feets - ✔✔Each EMT run between termination points shall be securely fastened
within _______feets of each outlet box, junction box, device box ,cabinet , conduit body,
or other tubing termination ?
✔✔5 telephones - ✔✔two way shall be tele capable of permitting the simultaneous
operation of any ______telephone stationsin a commun talked mode
✔✔13 wires of 12 AWG - ✔✔Consider a 4x4 Square electrical box that is 2 1/8" deep.
what is the maximum number of 12 AWG conductor which can be used?
✔✔10 feets - ✔✔EMT shall be security fastener in place at least every____feets
, ✔✔Maintained in safe condition - ✔✔all hand and power tools,whether furnished by
employee or employer, shall be?
✔✔Very Extra High - ✔✔A green color code green indication on a heat detector
indicates what operating temperature classification ?
✔✔4.04 ohms - ✔✔What is the wire resistance in ohm of 500 feet of 18 AWG solid
copper which is a coated at 75 degrees C?
✔✔96" AFF and a least 6" below the ceiling - ✔✔what is the appropriate mounting high
for audible notification appliance?
✔✔listed - ✔✔A multi criteria device shall be ____ for the primary function of the device
✔✔15% - ✔✔Spaces separated by a partition shall be considered as separate room for
projected beam smoke detectors when the partition extend to within what percentage of
the ceiling high?
✔✔Soft tissue injuries - ✔✔which of the following is caused by muscle pains and
spams?
✔✔3.19 ohm - ✔✔what is the wire resistance in ohms, of 1000 feet of 14 AWG solid
copper which is coated at 75 degrees C?
✔✔200 seconds - ✔✔a trouble signal shall be indicated and recorded
with____seconds?
✔✔Shunt - ✔✔What type of auxiliary fire alarm system does not permit the use of
automatic detectors?
✔✔110 % - ✔✔A steam pressure supervisory shall indicate a low pressure condition
.The off normal signal be initiated prior to the pressure falling below _____% of the
minimum operating equipment supplied?
✔✔7 AMP - ✔✔A non power limited fire alarm circuit which 18 AWG shall have over
current protection not to exceed ___ amperes?
✔✔The system designer - ✔✔the features for non required system shall be established
by _____ on the basis of the goals and objectives of the building owner ?
✔✔8.08 ohm - ✔✔What is the resistance in ohms, of 1000 feet of 18 AWG solid copper
which is coated at 75 degrees C?
