3/27/26, 8:58 PM Michigan SOS Brakes Mechanic Certification Practice Test Flashcards | Quizlet
Michigan SOS Brakes Mechanic Certification
Practice Test
Leave the first rating
1 Save
St udents also studied
Michigan SOS Brakes Mechanic Cert... Automotive Brake System ASE A5 Brakes Study Guide (Power A... NIPSTA Chapter 13
Teacher 43 terms Teacher 20 terms 9 terms 62 terms
cmuia6216 Preview ERPROWSE Preview purpleguy97 Preview eshilait8296
P ractice questions for this set
Learn 1/7 Study using Learn
A condition where the parking brake cable does not release properly, causing rear
brakes to drag.
Choose an answer
1 Stuck parking brake cable 2 Pumping the brake pedal
3 Faulty brake booster 4 Contaminated brake fluid
Don't know?
https://quizlet.com/1135269318/michigan-sos-brakes-mechanic-certification-practice-test-flash-cards/ 1/5
, 3/27/26, 8:58 PM Michigan SOS Brakes Mechanic Certification Practice Test Flashcards | Quizlet
Terms in this set (43)
Warped brake rotors A likely cause of the brake pedal slowly going to the floor when normal braking pressure
is applied.
Contaminated brake fluid A possible reason for the brake pedal slowly going to the floor under normal braking
pressure.
Internal leak in the master cylinder A common cause for the brake pedal going to the floor when normal braking pressure is
applied.
Faulty brake booster A potential issue that could cause the brake pedal to slowly go to the floor during a road
test.
Vacuum power brake booster test To test it, disconnect the vacuum hose and observe engine idle.
Brake pedal pumping test Pump the brake pedal at least 4 times, hold the brake pedal depressed, and start the
engine to test the vacuum power brake booster.
Parking brake application Apply the parking brake and start the engine as part of the vacuum power brake booster
test.
Vacuum check at the booster Check for vacuum at the booster with a gauge to test the vacuum power brake booster.
Depressurizing an ABS system The proper way includes opening the bleeder valves.
Disconnecting the ABS fuse A method to depressurize an ABS system.
Pumping the brake pedal Pump the brake pedal at least 25 times with the ignition off to depressurize an ABS system.
ABS self-diagnostic test Running this test is one way to depressurize an ABS system.
https://quizlet.com/1135269318/michigan-sos-brakes-mechanic-certification-practice-test-flash-cards/ 2/5
Michigan SOS Brakes Mechanic Certification
Practice Test
Leave the first rating
1 Save
St udents also studied
Michigan SOS Brakes Mechanic Cert... Automotive Brake System ASE A5 Brakes Study Guide (Power A... NIPSTA Chapter 13
Teacher 43 terms Teacher 20 terms 9 terms 62 terms
cmuia6216 Preview ERPROWSE Preview purpleguy97 Preview eshilait8296
P ractice questions for this set
Learn 1/7 Study using Learn
A condition where the parking brake cable does not release properly, causing rear
brakes to drag.
Choose an answer
1 Stuck parking brake cable 2 Pumping the brake pedal
3 Faulty brake booster 4 Contaminated brake fluid
Don't know?
https://quizlet.com/1135269318/michigan-sos-brakes-mechanic-certification-practice-test-flash-cards/ 1/5
, 3/27/26, 8:58 PM Michigan SOS Brakes Mechanic Certification Practice Test Flashcards | Quizlet
Terms in this set (43)
Warped brake rotors A likely cause of the brake pedal slowly going to the floor when normal braking pressure
is applied.
Contaminated brake fluid A possible reason for the brake pedal slowly going to the floor under normal braking
pressure.
Internal leak in the master cylinder A common cause for the brake pedal going to the floor when normal braking pressure is
applied.
Faulty brake booster A potential issue that could cause the brake pedal to slowly go to the floor during a road
test.
Vacuum power brake booster test To test it, disconnect the vacuum hose and observe engine idle.
Brake pedal pumping test Pump the brake pedal at least 4 times, hold the brake pedal depressed, and start the
engine to test the vacuum power brake booster.
Parking brake application Apply the parking brake and start the engine as part of the vacuum power brake booster
test.
Vacuum check at the booster Check for vacuum at the booster with a gauge to test the vacuum power brake booster.
Depressurizing an ABS system The proper way includes opening the bleeder valves.
Disconnecting the ABS fuse A method to depressurize an ABS system.
Pumping the brake pedal Pump the brake pedal at least 25 times with the ignition off to depressurize an ABS system.
ABS self-diagnostic test Running this test is one way to depressurize an ABS system.
https://quizlet.com/1135269318/michigan-sos-brakes-mechanic-certification-practice-test-flash-cards/ 2/5
