NEIEP
2024 NEIEP 800 Final Exam Version 2 (GRADED
A)Questions and VERIFIED SOLUTIONS
Hydro elevators in low rise applications do not need an room.
overhead machine
Some advantages of hydros are lower equipment and building construction
costs because the load of a hydro is carried to the where as the load
of a traction car is carried by the
.
ground, building structure
When drilling the jack hole, the only proper way to determine if the hole is
plumb is to
remove the drill stem and bit and use a
. Spider Bob
To plumb the hole, a spider bob is attached to a length of piano wire
suspended from as near as possible to the top of the or from a fixed
point on the drill rig. Hoistway
When welding a joint, lay inch tack welds degrees apart, shift it
90 degrees and lay
two more 1 inch tack welds 180
degrees apart. 1, 180
On power units having the motor beneath the tank, the pump may be either
driven or coupled.
belt, direct
The purpose of the / is to silence the effect of any pulsations in
the pump output and should be as close to the pump as possible.
silencer, muffler
2024 NEIEP 800 Final Exam Version 2 (GRADED A)Questions and VERIFIED SOLUTIONS
, NEIEP
On Bolsters/Bolster Assembly, the plunger is fastened to the
which is then mounted to the center of the Bolster Assembly.
platen plate
With wye-delta, reduced current starting is accomplished without the need
for . resistors
run buttons should run the platform and sling at leveling
speeds only. Temporary
A consists of a piston held closed by an adjustable spring and
must open at a certain pressure to prevent any further increase in pressure.
relief valve
A lowering valve allows the car to be lowered at a speed not
exceeding 20fpm in case of power failure. manual
As the oil temperature changes, the will change as well and
will effect the performance, more specifically, the leveling and
approach of the elevator. viscosity
Be sure wellways are properly to avoid accidental injury to you,
your team or anyone working outside of our industry. barricaded
Barricades around the wellway must be inches high and be capable
of withstanding a lb force.
42, 200
2024 NEIEP 800 Final Exam Version 2 (GRADED A)Questions and VERIFIED SOLUTIONS
2024 NEIEP 800 Final Exam Version 2 (GRADED
A)Questions and VERIFIED SOLUTIONS
Hydro elevators in low rise applications do not need an room.
overhead machine
Some advantages of hydros are lower equipment and building construction
costs because the load of a hydro is carried to the where as the load
of a traction car is carried by the
.
ground, building structure
When drilling the jack hole, the only proper way to determine if the hole is
plumb is to
remove the drill stem and bit and use a
. Spider Bob
To plumb the hole, a spider bob is attached to a length of piano wire
suspended from as near as possible to the top of the or from a fixed
point on the drill rig. Hoistway
When welding a joint, lay inch tack welds degrees apart, shift it
90 degrees and lay
two more 1 inch tack welds 180
degrees apart. 1, 180
On power units having the motor beneath the tank, the pump may be either
driven or coupled.
belt, direct
The purpose of the / is to silence the effect of any pulsations in
the pump output and should be as close to the pump as possible.
silencer, muffler
2024 NEIEP 800 Final Exam Version 2 (GRADED A)Questions and VERIFIED SOLUTIONS
, NEIEP
On Bolsters/Bolster Assembly, the plunger is fastened to the
which is then mounted to the center of the Bolster Assembly.
platen plate
With wye-delta, reduced current starting is accomplished without the need
for . resistors
run buttons should run the platform and sling at leveling
speeds only. Temporary
A consists of a piston held closed by an adjustable spring and
must open at a certain pressure to prevent any further increase in pressure.
relief valve
A lowering valve allows the car to be lowered at a speed not
exceeding 20fpm in case of power failure. manual
As the oil temperature changes, the will change as well and
will effect the performance, more specifically, the leveling and
approach of the elevator. viscosity
Be sure wellways are properly to avoid accidental injury to you,
your team or anyone working outside of our industry. barricaded
Barricades around the wellway must be inches high and be capable
of withstanding a lb force.
42, 200
2024 NEIEP 800 Final Exam Version 2 (GRADED A)Questions and VERIFIED SOLUTIONS
