SOLIDWORKS CSWA AM CERTIFICATION
EVALUATION TEST 2026 PRACTICE
SOLUTION QUESTIONS AND ANSWERS
●● p-method of meshing involves.
Answer: increasing mesh element polynomial order
●● is it possible to model breaking of glass on the floor using linear
static analysis?.
Answer: no
●● which of the following cases, the rope will most likely break?.
Answer: both are the same
●● Assuming a linear static study, if the Young's modulus of the material
is doubles (everything else remains the same), then the tensile stress will
be.
Answer: doubles
●● iso lot in the simulation will enable to.
Answer: set lower and upper limits to see desired stress range
, ●● which statement best describes a compatible mesh?.
Answer: a mesh where elements on touching bodies have overlaying
nodes
●● maximum and minimum value indicators are displayed on stress and
displacement plots in SOLIDWORKS simulation for a linear static
study.
Answer: true
●● what SOLIDWORKS simulation tool should you use to determine
the result values at specific locations (nodes) in a model using
SOLIDWORKS simulation?.
Answer: probe tool
●● what criteria are best suited to check the failure of ductile materials
in SOLIDWORKS simulation?.
Answer: maximum von Mises stress and maximum shear stress criterion
●● what is the modulus of elasticity?.
Answer: the slope of the stress-strain curve in its linear section
●● what is stress?.
Answer: a measure of average amount of force exerted per unit area
EVALUATION TEST 2026 PRACTICE
SOLUTION QUESTIONS AND ANSWERS
●● p-method of meshing involves.
Answer: increasing mesh element polynomial order
●● is it possible to model breaking of glass on the floor using linear
static analysis?.
Answer: no
●● which of the following cases, the rope will most likely break?.
Answer: both are the same
●● Assuming a linear static study, if the Young's modulus of the material
is doubles (everything else remains the same), then the tensile stress will
be.
Answer: doubles
●● iso lot in the simulation will enable to.
Answer: set lower and upper limits to see desired stress range
, ●● which statement best describes a compatible mesh?.
Answer: a mesh where elements on touching bodies have overlaying
nodes
●● maximum and minimum value indicators are displayed on stress and
displacement plots in SOLIDWORKS simulation for a linear static
study.
Answer: true
●● what SOLIDWORKS simulation tool should you use to determine
the result values at specific locations (nodes) in a model using
SOLIDWORKS simulation?.
Answer: probe tool
●● what criteria are best suited to check the failure of ductile materials
in SOLIDWORKS simulation?.
Answer: maximum von Mises stress and maximum shear stress criterion
●● what is the modulus of elasticity?.
Answer: the slope of the stress-strain curve in its linear section
●● what is stress?.
Answer: a measure of average amount of force exerted per unit area
