NICET 1 - Practice Fire Alarm Systems
Level I Exam Questions & Answers
(Grade A+)
According to NFPA 72, how often shall waterflow devices be tested?
-
correct answer ✅Annually
A wall-mounted visible appliance is being installed in a protected
premises that has a height of 6.75 feet. In this application, what is
the maximum distance from the ceiling that the appliance may be
mounted? -
correct answer ✅12 inches
For a Class B circuit, where is the end-of-line resistor located? -
correct answer ✅at the device physically farthest from the panel
Click on the Exhibit button.Which one of the symbols shown
represents a heat detector? -
correct answer ✅C
On a peaked ceiling, projected beam-type smoke detectors must be
installed within which maximum distance from the peak? -
correct answer ✅3 feet
, NICET 1 - Practice Fire Alarm Systems
Level I Exam Questions & Answers
(Grade A+)
Which one of the following is a parallel circuit? -
correct answer ✅a single heat detector
According to OSHA, which electrical cord is safe to use? -
correct answer ✅one that is free of cuts
In a conventional fire alarm system, which component serves as a
contact device that is normally open? -
correct answer ✅high- or low-air pressure switch
Cables installed under a corrugated metal roof deck must be
located at least which minimum distance from the roof deck? -
correct answer ✅1 1/2 inches (1.50)
After the fire alarm system installation has been completed, at what
interval should system smoke detectors undergo functional testing,
after the alarm contractor has performed the acceptance test of the
fire alarm system? -
correct answer ✅
Level I Exam Questions & Answers
(Grade A+)
According to NFPA 72, how often shall waterflow devices be tested?
-
correct answer ✅Annually
A wall-mounted visible appliance is being installed in a protected
premises that has a height of 6.75 feet. In this application, what is
the maximum distance from the ceiling that the appliance may be
mounted? -
correct answer ✅12 inches
For a Class B circuit, where is the end-of-line resistor located? -
correct answer ✅at the device physically farthest from the panel
Click on the Exhibit button.Which one of the symbols shown
represents a heat detector? -
correct answer ✅C
On a peaked ceiling, projected beam-type smoke detectors must be
installed within which maximum distance from the peak? -
correct answer ✅3 feet
, NICET 1 - Practice Fire Alarm Systems
Level I Exam Questions & Answers
(Grade A+)
Which one of the following is a parallel circuit? -
correct answer ✅a single heat detector
According to OSHA, which electrical cord is safe to use? -
correct answer ✅one that is free of cuts
In a conventional fire alarm system, which component serves as a
contact device that is normally open? -
correct answer ✅high- or low-air pressure switch
Cables installed under a corrugated metal roof deck must be
located at least which minimum distance from the roof deck? -
correct answer ✅1 1/2 inches (1.50)
After the fire alarm system installation has been completed, at what
interval should system smoke detectors undergo functional testing,
after the alarm contractor has performed the acceptance test of the
fire alarm system? -
correct answer ✅
