OSHA 30 CONSTRUCTION
FINAL EXAM TEST ANSWER
KEY
examples of fall hazards that have resulted in deaths on the jobsite include:
A. falls to the ground or lovver levels
B. falls through existing floor or roof openings
C. falls through the floor or roof surface
D. falls on the same level
E. all the above (ans:)
2. incident investigation should focus on:
A. assigning blame
B. understanding why the accident or near miss occurred
C. what actions can be taken to preclude recurrence.
D. both b and c above (ans:)
3. when pu•ve been assigned a new job or task, be sure to ask about die:
A. additional pay and benefits
B. 17me it takes to drive to the nearest osha office
C. medical expenses that all you co-mrkers may have
D. written procedures and any additional training that may be required (ans:)
4. underground electrical hazards are
A. easy to identify
B. hard to find & pose a serious risk to laborers & equipment operators (ans:)
C. always marked exactly where they are located
D. always buried in red concrete
5. underground electrical hazards are
A. easy to identify
B. hard to find & pose a serious risk to laborers & equipment operators (ans:)
C. always marked exactly where they are located
D. always buried in red concrete
6. although mechanical failures do occur, most accidents while working on with machinery can be
attributed to:
Page 1 of 10
, A. bad luck
B. failure to properly lock and tag out equipment (ans:)
C. bad start switch
D. none the above
7. flying object hazards are especially dangerous when using powder-acmated tools because:
A. -me force behind the fastener is low and can fool you
B. -me force behind the fastener is high and could go through a mrker ans:)
C. -me force behind the fastener doesnt matter
8. which shtement below is true regarding eye wash stations be provided on a job site?
A. osha has no requirement for eyewashes on construction job sites
B. emergency eyewash or shovver facilities must meet ansi requirements. (ans:)
C. emergency eye wash and shower stations must be reachable wthin 10 minutes.
D. -mere should be enough cold water to flush exposed surfaces for 45 minutes.
9. respiratory protection is required for exposed to hazardous nuterials above the permissible exposure
limit for particular hazardous materials and engineering controls cannot effectively control hazards.
what are die two general of respirators?
A. air expelling and air demanding
B. cool laminar now and pressure demand laminar now
C. air purifying and atmosphere supplying (ans:)
d. papr and uapr
10. what do we know about the hazard communication standard label requirements?
A. -mere is no standard format, just required elements (ans:)
B. -mere are 19 required elements
C. -mere are only 3 required elements
11. a ladder witl die following rating should not be used on the construction site?
A. type iaa
B. type ia
c. type il
d. type ill (ans:)
12. what do we know about the hazard communication standard label requirements?
A. -mere is no standard format, just required elements (ans:)
B. -mere are 19 required elements
C. -mere are only 3 required elements
13. a ladder witl die following rating should not be used on the construction site?
A. type iaa
B. type ia
AdvanceOnline — com, CareerSafe — (Youth), ClickSafetv — (also includes Roadway, CalfOSHA and Spanish), PureSafety — Redvecmr — h'"vvwxedvectorcom, Summit
Source — http:ff•.v.v\uhsicomfosha1030, 360Training — Turner Construction — and University of South Florida — usfoticenter org
FINAL EXAM TEST ANSWER
KEY
examples of fall hazards that have resulted in deaths on the jobsite include:
A. falls to the ground or lovver levels
B. falls through existing floor or roof openings
C. falls through the floor or roof surface
D. falls on the same level
E. all the above (ans:)
2. incident investigation should focus on:
A. assigning blame
B. understanding why the accident or near miss occurred
C. what actions can be taken to preclude recurrence.
D. both b and c above (ans:)
3. when pu•ve been assigned a new job or task, be sure to ask about die:
A. additional pay and benefits
B. 17me it takes to drive to the nearest osha office
C. medical expenses that all you co-mrkers may have
D. written procedures and any additional training that may be required (ans:)
4. underground electrical hazards are
A. easy to identify
B. hard to find & pose a serious risk to laborers & equipment operators (ans:)
C. always marked exactly where they are located
D. always buried in red concrete
5. underground electrical hazards are
A. easy to identify
B. hard to find & pose a serious risk to laborers & equipment operators (ans:)
C. always marked exactly where they are located
D. always buried in red concrete
6. although mechanical failures do occur, most accidents while working on with machinery can be
attributed to:
Page 1 of 10
, A. bad luck
B. failure to properly lock and tag out equipment (ans:)
C. bad start switch
D. none the above
7. flying object hazards are especially dangerous when using powder-acmated tools because:
A. -me force behind the fastener is low and can fool you
B. -me force behind the fastener is high and could go through a mrker ans:)
C. -me force behind the fastener doesnt matter
8. which shtement below is true regarding eye wash stations be provided on a job site?
A. osha has no requirement for eyewashes on construction job sites
B. emergency eyewash or shovver facilities must meet ansi requirements. (ans:)
C. emergency eye wash and shower stations must be reachable wthin 10 minutes.
D. -mere should be enough cold water to flush exposed surfaces for 45 minutes.
9. respiratory protection is required for exposed to hazardous nuterials above the permissible exposure
limit for particular hazardous materials and engineering controls cannot effectively control hazards.
what are die two general of respirators?
A. air expelling and air demanding
B. cool laminar now and pressure demand laminar now
C. air purifying and atmosphere supplying (ans:)
d. papr and uapr
10. what do we know about the hazard communication standard label requirements?
A. -mere is no standard format, just required elements (ans:)
B. -mere are 19 required elements
C. -mere are only 3 required elements
11. a ladder witl die following rating should not be used on the construction site?
A. type iaa
B. type ia
c. type il
d. type ill (ans:)
12. what do we know about the hazard communication standard label requirements?
A. -mere is no standard format, just required elements (ans:)
B. -mere are 19 required elements
C. -mere are only 3 required elements
13. a ladder witl die following rating should not be used on the construction site?
A. type iaa
B. type ia
AdvanceOnline — com, CareerSafe — (Youth), ClickSafetv — (also includes Roadway, CalfOSHA and Spanish), PureSafety — Redvecmr — h'"vvwxedvectorcom, Summit
Source — http:ff•.v.v\uhsicomfosha1030, 360Training — Turner Construction — and University of South Florida — usfoticenter org
