ICC Fire Inspector II (FII) Questions And Correct
Answers (Verified Answers) Plus Rationales
2026 Q&A | Instant Download Pdf
1. Which NFPA standard provides requirements for the installation of
fire alarm systems?
A. NFPA 13
B. NFPA 72
C. NFPA 101
D. NFPA 25
Rationale: NFPA 72, the National Fire Alarm and Signaling Code, sets the
requirements for the installation, performance, inspection, testing, and
maintenance of fire alarm systems, making it the primary reference for
fire alarm systems.
2. A fire inspector identifies that a building's egress doors swing
inward into the corridor. According to most building codes, this is:
A. Acceptable for doors serving fewer than 50 people
B. Not acceptable for doors serving an occupant load greater
than 50
, C. Acceptable if the doors are equipped with panic hardware
D. Acceptable if the corridor is at least 8 feet wide
Rationale: Doors serving high occupant loads must swing in the
direction of egress to prevent crowding and facilitate safe evacuation.
This is consistent with IBC and NFPA life safety requirements.
3. In fire inspection reports, the term “means of egress” refers to:
A. The fire department’s access route to the building
B. A fire suppression system
C. A continuous and unobstructed path from any point in a
building to a public way
D. Only the exterior doors of a building
Rationale: “Means of egress” includes exit access, exits, and exit
discharge. It ensures that occupants can safely evacuate to a public way
without encountering hazards.
4. What is the minimum clear width for a stairway serving an
occupant load of 100 people?
A. 28 inches
B. 32 inches
C. 44 inches
D. 60 inches
,Rationale: According to NFPA 101, Life Safety Code, and the IBC,
stairways serving an occupant load exceeding 50 require a minimum
width of 44 inches to allow safe egress.
5. Which of the following is a common combustible construction
material that requires special consideration during fire
inspections?
A. Steel
B. Concrete
C. Wood
D. Glass
Rationale: Wood is combustible and can contribute to fire growth and
spread. Inspectors must ensure that fire-resistive treatments and proper
fire protection measures are in place.
6. During an inspection, a fire inspector notes that the fire sprinkler
system is obstructed by stored items. The correct action is to:
A. Ignore the obstruction if it is less than 6 inches from the ceiling
B. Note the obstruction in the inspection report and require
correction
C. Remove the items immediately without notifying management
D. Increase the water pressure in the system
, Rationale: Obstructions to sprinkler heads reduce coverage and
effectiveness. NFPA 13 requires unobstructed sprinkler operation, and
fire inspectors must document and enforce corrective action.
7. A building is equipped with an automatic sprinkler system. What is
the minimum temperature rating for sprinklers in a storage room
with ambient temperatures of 100°F?
A. 135°F
B. 155°F
C. 175°F
D. 200°F
Rationale: Sprinkler temperature ratings must exceed the maximum
expected ambient temperature to prevent accidental activation. NFPA
13 specifies that sprinklers in 100°F ambient conditions require at least
175°F rating.
8. The fire inspector’s primary responsibility during a fire prevention
inspection is to:
A. Operate fire alarm systems
B. Identify hazards and ensure compliance with fire and life
safety codes
C. Conduct fire drills
D. Design fire protection systems
Answers (Verified Answers) Plus Rationales
2026 Q&A | Instant Download Pdf
1. Which NFPA standard provides requirements for the installation of
fire alarm systems?
A. NFPA 13
B. NFPA 72
C. NFPA 101
D. NFPA 25
Rationale: NFPA 72, the National Fire Alarm and Signaling Code, sets the
requirements for the installation, performance, inspection, testing, and
maintenance of fire alarm systems, making it the primary reference for
fire alarm systems.
2. A fire inspector identifies that a building's egress doors swing
inward into the corridor. According to most building codes, this is:
A. Acceptable for doors serving fewer than 50 people
B. Not acceptable for doors serving an occupant load greater
than 50
, C. Acceptable if the doors are equipped with panic hardware
D. Acceptable if the corridor is at least 8 feet wide
Rationale: Doors serving high occupant loads must swing in the
direction of egress to prevent crowding and facilitate safe evacuation.
This is consistent with IBC and NFPA life safety requirements.
3. In fire inspection reports, the term “means of egress” refers to:
A. The fire department’s access route to the building
B. A fire suppression system
C. A continuous and unobstructed path from any point in a
building to a public way
D. Only the exterior doors of a building
Rationale: “Means of egress” includes exit access, exits, and exit
discharge. It ensures that occupants can safely evacuate to a public way
without encountering hazards.
4. What is the minimum clear width for a stairway serving an
occupant load of 100 people?
A. 28 inches
B. 32 inches
C. 44 inches
D. 60 inches
,Rationale: According to NFPA 101, Life Safety Code, and the IBC,
stairways serving an occupant load exceeding 50 require a minimum
width of 44 inches to allow safe egress.
5. Which of the following is a common combustible construction
material that requires special consideration during fire
inspections?
A. Steel
B. Concrete
C. Wood
D. Glass
Rationale: Wood is combustible and can contribute to fire growth and
spread. Inspectors must ensure that fire-resistive treatments and proper
fire protection measures are in place.
6. During an inspection, a fire inspector notes that the fire sprinkler
system is obstructed by stored items. The correct action is to:
A. Ignore the obstruction if it is less than 6 inches from the ceiling
B. Note the obstruction in the inspection report and require
correction
C. Remove the items immediately without notifying management
D. Increase the water pressure in the system
, Rationale: Obstructions to sprinkler heads reduce coverage and
effectiveness. NFPA 13 requires unobstructed sprinkler operation, and
fire inspectors must document and enforce corrective action.
7. A building is equipped with an automatic sprinkler system. What is
the minimum temperature rating for sprinklers in a storage room
with ambient temperatures of 100°F?
A. 135°F
B. 155°F
C. 175°F
D. 200°F
Rationale: Sprinkler temperature ratings must exceed the maximum
expected ambient temperature to prevent accidental activation. NFPA
13 specifies that sprinklers in 100°F ambient conditions require at least
175°F rating.
8. The fire inspector’s primary responsibility during a fire prevention
inspection is to:
A. Operate fire alarm systems
B. Identify hazards and ensure compliance with fire and life
safety codes
C. Conduct fire drills
D. Design fire protection systems
