1
MED GAS Exam Questions with
100% Correct Answers Latest
What is not part of a typical Cat. 1 medical vacuum system?
Patient Lead
An oxygen-enriched atmosphere is the concentration of
oxygen that exceeds ______ percent by volume.
23.5%
Categories shall be determined by following and
documenting a defined risk assessment procedure.
True
Within a single patient room or Cat 1 space to provide access
for two or more gases through a common delivery system,
which system shall be used?
Surface-Mounted Medical Gas rail systems. (Vacuums have an
Inlet and a slide)
A factory assembled product designed for aesthetics or
convenience that contains medical gas outlets or vacuum
outlets, piping, or other devices related to medical gases is
a_____?
Manufactured assembly
Manufactures shall design their medical air compressors to
exclude______ from the air stream and compression
chamber.
Oil
The use of adapters or conversion fittings to adapt on gas
specific fitting to another shall be allowed for testing and
verification only.
False
Which of the following systems shall not be permitted to be
located in an outdoor enclosure?
Instrument air sources
, 2
Indoor locations for oxygen, nitrogen oxide and mixtures of
these gases shall not communicate with _____ Locations.
Anesthetizing
Cylinder in use and in storage shall be prevented from
reaching temps in excess of_______?
125 degrees F
Where the total volume of medical gases is greater than
3,000ft3, indoor supply locations shall be provided with what
type of ventilation?
Mechanical
What is required downstream of each regulator or
immediately downstream of the isolating valves for the
regulators?
Pressure Indicator
Relief valves for all positive pressure supply systems shall
have at least one relief valve made of brass, bronze,
or______?
Stainless Steel
in central supply systems, using gas cylinders, a ________ is
at each connection for the cylinder or leads to prevent loss
of gas in the event of damage.
Check Valve
Manifolds for gas cylinders shall actuate a _______ and shall
activate an indicator at the ________ Alarm panels to indicate
when or just before a changeover from one header to the
other.
Local Signal; Master
The gas produced by evaporation from the secondary header
in a cryogenic liquid cylinder system shall enter the supply
system ______ of the final line regulator
Upstream
Where the bulk cryogenic liquid oxygen supply system is
outside a building, a(n)______ connection shall be installed.
Emergency oxygen supply
MED GAS Exam Questions with
100% Correct Answers Latest
What is not part of a typical Cat. 1 medical vacuum system?
Patient Lead
An oxygen-enriched atmosphere is the concentration of
oxygen that exceeds ______ percent by volume.
23.5%
Categories shall be determined by following and
documenting a defined risk assessment procedure.
True
Within a single patient room or Cat 1 space to provide access
for two or more gases through a common delivery system,
which system shall be used?
Surface-Mounted Medical Gas rail systems. (Vacuums have an
Inlet and a slide)
A factory assembled product designed for aesthetics or
convenience that contains medical gas outlets or vacuum
outlets, piping, or other devices related to medical gases is
a_____?
Manufactured assembly
Manufactures shall design their medical air compressors to
exclude______ from the air stream and compression
chamber.
Oil
The use of adapters or conversion fittings to adapt on gas
specific fitting to another shall be allowed for testing and
verification only.
False
Which of the following systems shall not be permitted to be
located in an outdoor enclosure?
Instrument air sources
, 2
Indoor locations for oxygen, nitrogen oxide and mixtures of
these gases shall not communicate with _____ Locations.
Anesthetizing
Cylinder in use and in storage shall be prevented from
reaching temps in excess of_______?
125 degrees F
Where the total volume of medical gases is greater than
3,000ft3, indoor supply locations shall be provided with what
type of ventilation?
Mechanical
What is required downstream of each regulator or
immediately downstream of the isolating valves for the
regulators?
Pressure Indicator
Relief valves for all positive pressure supply systems shall
have at least one relief valve made of brass, bronze,
or______?
Stainless Steel
in central supply systems, using gas cylinders, a ________ is
at each connection for the cylinder or leads to prevent loss
of gas in the event of damage.
Check Valve
Manifolds for gas cylinders shall actuate a _______ and shall
activate an indicator at the ________ Alarm panels to indicate
when or just before a changeover from one header to the
other.
Local Signal; Master
The gas produced by evaporation from the secondary header
in a cryogenic liquid cylinder system shall enter the supply
system ______ of the final line regulator
Upstream
Where the bulk cryogenic liquid oxygen supply system is
outside a building, a(n)______ connection shall be installed.
Emergency oxygen supply
