Power Engineering 4B Book 12 Plant
Configuration| All Correct Updated
Answers
a - Ans--An emergency shutdown (ESD) of a hot oil system may be
activated
a) Manually
b) Only by the shift charge engineer
c) Only by the first responder
d) By high excess o2 measured at the stack
b - Ans--To transport bitumen through a pipeline, it must be diluted with
a) carson
b) diluent
c) water
d) produced water
d - Ans--What is the primary use of ground wood pulp, produced by the
mechanical process
a) cardboard
b) soft paper products
c) high quality white paper
d) Newsprint
c - Ans--With regard to hot oil leaving the heater, the operating parameter of
particular importance is the oil
a) pressure
b) velocity
c) Temperature
d) Viscosity
, b - Ans--The purpose of stabilization in natural gas plants is to
a) stabilize the gas from the contractor
b) Flash off lighter gases at low-pressure, from the liquid hydrocarbons
c) Prevent lighter hydrocarbons from separating from the heavier
hydrocarbons
d) Flash off the gases at high pressure from the liquids
b - Ans--The discharge from the safety valve on a hot oil system is directed
to
a) the pump suction
b) the surge tank
c) a floor drain
d) the roof of a boiler house
d - Ans--Hot oil high temperature shutdown (TSDH) switches are installed
on the
a) inlet line to the oil heater
b) inlet line to the pump
c) surge tank inlet line
d) outlet line from the heater
b - Ans--Chemical pulping processes result in ________ of the raw forest
material input
a) a 25% loss by weight
b) a 50% loss by weight
c) an insignificant loss
d) the most efficient use
b - Ans--the purpose of an inlet separator in a natural gas plant is to remove
the
a) undissolved gases from the hydrocarbons
b) liquids from the gas
Configuration| All Correct Updated
Answers
a - Ans--An emergency shutdown (ESD) of a hot oil system may be
activated
a) Manually
b) Only by the shift charge engineer
c) Only by the first responder
d) By high excess o2 measured at the stack
b - Ans--To transport bitumen through a pipeline, it must be diluted with
a) carson
b) diluent
c) water
d) produced water
d - Ans--What is the primary use of ground wood pulp, produced by the
mechanical process
a) cardboard
b) soft paper products
c) high quality white paper
d) Newsprint
c - Ans--With regard to hot oil leaving the heater, the operating parameter of
particular importance is the oil
a) pressure
b) velocity
c) Temperature
d) Viscosity
, b - Ans--The purpose of stabilization in natural gas plants is to
a) stabilize the gas from the contractor
b) Flash off lighter gases at low-pressure, from the liquid hydrocarbons
c) Prevent lighter hydrocarbons from separating from the heavier
hydrocarbons
d) Flash off the gases at high pressure from the liquids
b - Ans--The discharge from the safety valve on a hot oil system is directed
to
a) the pump suction
b) the surge tank
c) a floor drain
d) the roof of a boiler house
d - Ans--Hot oil high temperature shutdown (TSDH) switches are installed
on the
a) inlet line to the oil heater
b) inlet line to the pump
c) surge tank inlet line
d) outlet line from the heater
b - Ans--Chemical pulping processes result in ________ of the raw forest
material input
a) a 25% loss by weight
b) a 50% loss by weight
c) an insignificant loss
d) the most efficient use
b - Ans--the purpose of an inlet separator in a natural gas plant is to remove
the
a) undissolved gases from the hydrocarbons
b) liquids from the gas
