Page | 1
NEIEP 800 FINAL REVIEW 2026
QUESTIONS AND ANSWERS| ACE YOUR
GRADES.
1. How is the right or left side of a stairway determined? -
Standing at the bottom and looking up.
2. What type of pump system delivers constant volume at all
pressures? - Positive displacement gear pump
3. What best describes the pinion of the governor safety device? -
It free wheels until the hoist exceeds tripping speed in the down
direction
4. What is the maximum allowable rated load for a LULA
elevator? - 1,400 Ibs.
5. Layout. What is the correct distance to the center of wellway
from the column line? - 17' 6 3/4"
, Page | 2
6. The platen plate connects which two hydraulic elevator
components together? - Plunger and bolster assembly
7. Submersible pump units are always designed by which of the
following methods? - Direct coupled motor and pump
8. What is the maximum angle of inclination allowable for a
moving walk? - 12 degrees
9. You are performing an acceptance test and must document the
working pressure. What must be done to record this pressure?
- Run the elevator up with full load
10. Which of the following is the minimum rated load for both a
one- and a two-seat chairlift, respectively? - 250lb, 400lb
11. If a jack or cylinder floats in the jack hole, what step may be
needed to overcome this? - Add oil to the cylinder
NEIEP 800 FINAL REVIEW 2026
QUESTIONS AND ANSWERS| ACE YOUR
GRADES.
1. How is the right or left side of a stairway determined? -
Standing at the bottom and looking up.
2. What type of pump system delivers constant volume at all
pressures? - Positive displacement gear pump
3. What best describes the pinion of the governor safety device? -
It free wheels until the hoist exceeds tripping speed in the down
direction
4. What is the maximum allowable rated load for a LULA
elevator? - 1,400 Ibs.
5. Layout. What is the correct distance to the center of wellway
from the column line? - 17' 6 3/4"
, Page | 2
6. The platen plate connects which two hydraulic elevator
components together? - Plunger and bolster assembly
7. Submersible pump units are always designed by which of the
following methods? - Direct coupled motor and pump
8. What is the maximum angle of inclination allowable for a
moving walk? - 12 degrees
9. You are performing an acceptance test and must document the
working pressure. What must be done to record this pressure?
- Run the elevator up with full load
10. Which of the following is the minimum rated load for both a
one- and a two-seat chairlift, respectively? - 250lb, 400lb
11. If a jack or cylinder floats in the jack hole, what step may be
needed to overcome this? - Add oil to the cylinder
