ADDA MECHANICAL DRAFTER CERTIFICATION PRACTICE - PART II WITH QUESTIONS AND ANSWERS. GRADED A+

ADDA MECHANICAL DRAFTER
CERTIFICATION PRACTICE - PART II WITH
QUESTIONS AND CORRECT DETAILED
ANSWERS. GRADED A+

QUESTIONS AND ANSWERS
18. ANSWER - A gear that has 20 teeth has __ degrees between each tooth.


45. ANSWER - The hatch for cast iron is usually equally-spaced lines drawn at a __ degree
angle.


3/8. ANSWER - The closest dimension line to the object view is drawn __ inches away
from the view.


general. ANSWER - Notes that pertain to the entire drawing are called __________ notes.


30. ANSWER - An isometric drawing shows front and right sides angled back at __
degrees to the horizontal.


aligned. ANSWER - A section in which the cutting plane line bends at angles less than 90
degrees is a(n) __________ section.


writing utensil. ANSWER - Sketching requires only a(n) __________ and a writing
medium.


writing medium. ANSWER - Sketching requires only a writing utensil and a(n)
__________.


16. ANSWER - The perimeter of a square measuring 4 inches per side is __ inches.


size. ANSWER - __________ and location are the two types of linear dimensions.