ICC CODES QUESTIONS AND ANSWERS.pdf/ 2026 with
ICCSolution
CODES QUESTIONS AND ANSWERS ICC CODES QUESTIONS AND ANSWERS.pdf
ICC CODES QUESTIONS AND ANSWERS
ACI 318
Which of the following publications is most useful for a Special Inspector?
Beam
A ____ is a horizontal member that transfers loads laterally.
Concrete with less than the minimum amount of reinforcement
Plain concrete refers to:
Flexure, compression
A beam is primarily subject to _____ while a column is primarily subject to ______.
Chapter 2
The best place to look up definitions in ACI 318-14 is:
Shallow
Foundations cast at the same elevation as the soil grade are known as:
Aggregate, sand, cement and water
Concrete is a mixture of
ASTM C150, ASTM C33
Portland cement must conform to _______ and normal-weight aggregate must conform to _______ in
all concrete.
Potable or non-potable water, cementitious material and aggregate conforming to ASTM C33
Structural normal weight concrete MUST contain/produce
Is an exothermic (heat producing), chemical reaction that begins when water and cement are combined
Hydration
2 inches
The maximum allowable nominal aggregate size for concrete used in a 6 inch thick slab is:
ASTM C260
What must air entrainment admixtures conform to?
Decrease the compressive strength
ICC CODES QUESTIONS AND ANSWERS.pdf ICC CODES QUESTIONS AND ICC
ANSWERS
CODES QUESTIONS AND ANSWERS.pdf/ 2026 with Solution
, ICC CODES QUESTIONS AND ANSWERS.pdf/ 2026 with
ICCSolution
CODES QUESTIONS AND ANSWERS ICC CODES QUESTIONS AND ANSWERS.pdf
Adding water to a concrete mix will:
The compressive strength will likely be higher than normal.
A concrete mix design specifies a water/cement ratio of 0.45 maximum. When batched, a particular load
has a water/cement ratio of 0.38. Which of the following statements is true?
7/8 of an inch (#22)
An ASTM A615 #7 bar has the diameter of
ASTM A706
A low-alloy steel bar conforms to
It is used only in spiral reinforcing
Plain reinforcement is acceptable for use in structural concrete provided that
A minimum yield strength of 60,000 psi
A grade 60 bar has
#9 plain bar, #9 deformed bar
Which bar has the largest nominal diameter?
90 degrees or 180 degrees
Standard hooks for deformed bars in tension are either ____ or _____.
4
Bundled bars can have a maximum of ____ bars bundled together.
#11
The largest allowable rebar diameter allowed in bundled bars in beams is:
Grade 80
Which type of rebar has the highest tensile strength?
It provides better adherence to concrete
Why is most rebar deformed?
9 inches
The minimum bend diameter of a number 9 standard hook in tension is:
Light coating of rust
Which of the following is permitted on reinforcing steel?
1-1/2 inches
ICC CODES QUESTIONS AND ANSWERS.pdf ICC CODES QUESTIONS AND ICC
ANSWERS
CODES QUESTIONS AND ANSWERS.pdf/ 2026 with Solution
ICCSolution
CODES QUESTIONS AND ANSWERS ICC CODES QUESTIONS AND ANSWERS.pdf
ICC CODES QUESTIONS AND ANSWERS
ACI 318
Which of the following publications is most useful for a Special Inspector?
Beam
A ____ is a horizontal member that transfers loads laterally.
Concrete with less than the minimum amount of reinforcement
Plain concrete refers to:
Flexure, compression
A beam is primarily subject to _____ while a column is primarily subject to ______.
Chapter 2
The best place to look up definitions in ACI 318-14 is:
Shallow
Foundations cast at the same elevation as the soil grade are known as:
Aggregate, sand, cement and water
Concrete is a mixture of
ASTM C150, ASTM C33
Portland cement must conform to _______ and normal-weight aggregate must conform to _______ in
all concrete.
Potable or non-potable water, cementitious material and aggregate conforming to ASTM C33
Structural normal weight concrete MUST contain/produce
Is an exothermic (heat producing), chemical reaction that begins when water and cement are combined
Hydration
2 inches
The maximum allowable nominal aggregate size for concrete used in a 6 inch thick slab is:
ASTM C260
What must air entrainment admixtures conform to?
Decrease the compressive strength
ICC CODES QUESTIONS AND ANSWERS.pdf ICC CODES QUESTIONS AND ICC
ANSWERS
CODES QUESTIONS AND ANSWERS.pdf/ 2026 with Solution
, ICC CODES QUESTIONS AND ANSWERS.pdf/ 2026 with
ICCSolution
CODES QUESTIONS AND ANSWERS ICC CODES QUESTIONS AND ANSWERS.pdf
Adding water to a concrete mix will:
The compressive strength will likely be higher than normal.
A concrete mix design specifies a water/cement ratio of 0.45 maximum. When batched, a particular load
has a water/cement ratio of 0.38. Which of the following statements is true?
7/8 of an inch (#22)
An ASTM A615 #7 bar has the diameter of
ASTM A706
A low-alloy steel bar conforms to
It is used only in spiral reinforcing
Plain reinforcement is acceptable for use in structural concrete provided that
A minimum yield strength of 60,000 psi
A grade 60 bar has
#9 plain bar, #9 deformed bar
Which bar has the largest nominal diameter?
90 degrees or 180 degrees
Standard hooks for deformed bars in tension are either ____ or _____.
4
Bundled bars can have a maximum of ____ bars bundled together.
#11
The largest allowable rebar diameter allowed in bundled bars in beams is:
Grade 80
Which type of rebar has the highest tensile strength?
It provides better adherence to concrete
Why is most rebar deformed?
9 inches
The minimum bend diameter of a number 9 standard hook in tension is:
Light coating of rust
Which of the following is permitted on reinforcing steel?
1-1/2 inches
ICC CODES QUESTIONS AND ANSWERS.pdf ICC CODES QUESTIONS AND ICC
ANSWERS
CODES QUESTIONS AND ANSWERS.pdf/ 2026 with Solution
