CSWA SIMULATION QUESTIONS WITH CORRECT ANSWERS

CSWASIMULATIONQUESTIONSWITH v v v




CORRECT ANSWERS 2025 v v v




H-method of meshing involves - CORRECT ANSWER -increasing mesh density
v v v v v v v v v




P-method of meshingPinvolves - CORRECT ANSWER -increasing mesh elementpolynomial order
v v v v v v v v v v




Is it possible to model breaking of glass on the floor using linear static analysis? -
v v v v v v v v v v v v v v v




CORRECT ANSWER -no
v v v




Which of the following cases, the rope will most likely break? - CORRECT ANSWER - both
v v v v v v v v v v v v v v v




are the same
v v v




Assuming a linear staticstudy, if the Young'smodulus of the material isdoubles (everything else remains
v v v v v v v v v v v v v v v v




the same), then the tensile stress will be - CORRECT ANSWER -doubles
v v v v v v v v v v v v




Iso lot in the simulation will enable to - CORRECT ANSWER - set
v v v v v v v v v v v v




lower and upper limits to see desired stress range
v v v v v v v v v




Which statementbestdescribes a compatible mesh? - CORRECT ANSWER- a
v v v v v v v v v v v




mesh where elements on touching bodies have overlaying nodes
v v v v v v v v v




Maximum and minimumvalue indicators aredisplayed on stress and displacement plots in SOLI DWORKS
v v v v v v v v v v v v v v




simulation for a linear static study - CORRECT ANSWER -true
v v v v v v v v v v




What SOLIDWORKS simulation tool should you use to determine the resultvalues at specificPloca tions
v v v v v v v v v v v v v v




(nodes) in a model using SOLIDWORKS simulation? - CORRECT ANSWER -probe tool
v v v v v v v v v v v v

, What criteria are best suited to check the failure of ductile materials in SOLIDWORKS simulation
v v v v v v v v v v v v v v




?- CORRECT ANSWER -maximum von Mises stress and maximum shear stress criterion
v v v v v v v v v v v v




What is the modulus of elasticity? - CORRECT ANSWER -the slope of the stress- strain
v v v v v v v v v v v v v v




curve in its linear section
v v v v v




What is stress? - CORRECT ANSWER -
v v v v v v




a measure of average amount of force exerted per unit area
v v v v v v v v v v




Which of the following assumptions are true for a static analysis in SOLIDWORKS simulation with small
v v v v v v v v v v v v v v v




displacements? - CORRECT ANSWER -
v v v v v




1. Inertia effects are negligible and loads are applied slowly v v v v v v v v




2. All the displacements are small relative to the model geometry
v v v v v v v v v




3. Resultsare proportional to loads v v v v




What is yield stress? - CORRECT ANSWER -
v v v v v v v




the stress level beyond which the material becomes plastic
v v v v v v v v




A high-quality shell element has ____ nodes. - CORRECT ANSWER -6
v v v v v v v v




Stress is proportional to v v v v in linear elastic material. - CORRECT ANSWER -strain
v v v v v v v




The elastic modulus (Young's modulus) is the slope defined as
v v v v v v v v v v divided by v v .- v




CORRECT ANSWER -stress, strain
v v v v




Linear staticPanalysis assumes that the relationship between loadsand theinduced response is: -
v v v v v v v v v v v v v




CORRECT ANSWER -linear
v v v