F13 Residential Building Contractor Exam Sample Questions 100% Pass

F13 Residential Building Contractor Exam Sample Questions 100% Pass The self-weight of the structural members normally provides the largest portion of the _____ load of a building. A. Dead B. Live C. Wind D. Heavy A. Dead R301.4 Dead load. What distance is required between masonry veneer and sheathing? A. .5 inch B. 1 inch C. 1.5 inch D. 2 inch B. 1 inch FIGURE R703.8 What is the maximum stud spacing of 2X6 bearing walls when supporting two floors, roof and ceiling (inches). A. 16 B. 19.2 C. 24 D. 32 A. 16 TABLE R602.3(5) A wood 2X6 nominal stud is part of a bearing wall. A slot needs to be notched to accommodate a pipe. What would be the maximum depth of the notch used to accommodate that pipe? A. 1.0" B. 1.375" C. 2.25" D. 3.0" C. 2.25" FIGURE R602.6(1) NOTCHING AND BORED HOLE LIMITATIONS FOR EXTERIOR WALLS AND BEARING WALLS Additions, alterations or repairs and relocations shall not cause a(n) __________________ to become unsafe or adversely affect the performance of the building. A. existing structure B. new structure C. temporary D. none of the above A. existing structure R102.7.1 Additions, alterations or repairs. What is minimum specified compressive strength of concrete basement walls in psi, foundations and other concrete not exposed to the weather with moderate weathering potential. A. 2500 B. 3000 C. 3500 D. 3750 A. 2500 TABLE R402.2 Glazing in an individual fixed or operable panel adjacent to a door where the nearest vertical edge of the glazing is within a ______ inch arc of either vertical edge of the door in a closed position and where the bottom exposed edge of the glazing is less than _______ inches above the floor or walking surface shall be considered a hazardous location. A. 24, 60 B. 78, 78 C. 72, 72 D. 48, 48 A. 24, 60 R308.4.2 Glazing adjacent to doors.