Series circuit Study guides, Study notes & Summaries

What is the result if the neutral wire becomes open on a multiwire circuit having unequal loads? Select one: a. The load of higher resistance would overheat and probably be damaged. b. The load of lesser resistance would overheat and probably be damaged. c. No effect until one load is turned off or opens. d. No effect. The load of higher resistance would overheat and probably be damaged. Refer to Figure 128.202. ___ volts are applied across the water heater element. S...

When connecting a 3-phase motor the three lines (T1,T2 and T3) are usually connected to __________. - L1, L2, and L3 Electricians use __________ to prevent damage to electrical wiring running to the machine. - rigid and flexible conduit When the wire or foil strip inside a fuse melts, the fuse is said to be __________. - blown The difference between a fuse and a circuit breaker is __________. - circuit breakers can be reset and used again The amount two electrical...

NEIEP 600 Final Exam Version 2 (Latest 2024 / 2025 Update) Questions and Verified Answers | 100% Correct | Grade A Q: What is the time constant for a circuit with 150 K ohms and 2 microfarad capacitor? (TC = R x C) Answer: 0.3 seconds Q: How long will it take for this capacitor to be considered fully charged? Answer: 1.5 seconds Q: The voltage required to cause conduction across the junction in a germa- nium diode is? Answer: 0.3 Q: A 1.5 volt 8 milliamp light emitting diode needs to be operated...

CCDS IBHRE LATEST UPDATE ALREADY GRADED A Rheobase the lowest point on a strength duration curve at an infinitely long pulse duration Chronaxie time the pulse width at twice the rheobase value. It approximates the most efficient stimulation pulse duration Charge (formula) Charge= I(current) x T(time) Furman's formula Energy(microjoules)= I(current)xV(voltage)xT(pulse width) Ohms law formula Voltage(electromotive force)= I(current/flow of electrons) x R(resistance to current flow in ohms) F...

NEIEP 700 Final Exam Version 2 (Latest 2023/ 2024 Update) Questions and Verified Answers| 100% Correct| Grade A Q: What is the primary reason AC relays hum or chatter? Answer: AC cycle reversal Q: Which of the following best describes the contact rating of a magnetic switch? Answer: The maximum voltage and current that can be safely interrupted Q: How can you reduce contact arcing on plug-in relay contacts? Answer: Wire two contacts of the same relay in series ...

NEIEP 700 Final Exam Version 2 (Latest 2024 / 2025 Update) Questions and Verified Answers | 100% Correct | Grade A Q: What is the primary reason AC relays hum or chatter? Answer: AC cycle reversal Q: Which of the following best describes the contact rating of a magnetic switch? Answer: The maximum voltage and current that can be safely interrupted Q: How can you reduce contact arcing on plug-in relay contacts? Answer: Wire two contacts of the same relay in series Q: How are latching relays reset...

1. A contractor wants to raise the car speed from 100fpm to 125fpm, it currently has a 12" sheave. What sheave is required?: Diam=12" 12/4=3" 25fpm=3" 100fpm + 25fpm= 12"+3"= 15" sheave 2. A MOV (Metal Oxide Varistor) burns out. You replace it, but cannot read voltage or resistance. What should you do?: Replace it with a larger MOV 3. On a Ward-Leonard circuit the break is set, but the motor is trying to slip through the break. What is the issue?: Suicide Circuit 4. You have an old DC ...

Fire Investigator TCFP Exam| 500+ Practice Questions and Verified Answers| 2023/ 2024 Update Q: What is the ability of a structural assembly to maintain its load-bearing capacity and structural integrity under fire conditions Answer: A.) Fire resistance Q: What would most likely need to happen for the fuel-gas product to ignite in the piping system Answer: C.) Leak from the system Q: What can the fire investigator conclude when the electrical safety devices operated ...

A contractor wants to raise the car speed from 100fpm to 125fpm, it currently has a 12" sheave. What sheave is required? - Diam=12" 12/4=3" 25fpm=3" 100fpm + 25fpm= 12"+3"= 15" sheave A MOV (Metal Oxide Varistor) burns out. You replace it, but cannot read voltage or resistance. What should you do? - Replace it with a larger MOV On a Ward-Leonard circuit the break is set, but the motor is trying to slip through the break. What is the issue? - Suicide Circuit You have an old DC motor ...

ATT Test 2 Questions and Answers Latest Updated 2023 Definition of series circuit Current flows in a single path through all components In which direction does current flow? Negative to positive Current is the ____ throughout whole circuit Same 4 steps of troubleshooting Analyze, check setup, calculate/measure, check results An open series component drops _____ volts Applied Resistance is how much over open component? Max or infinite Short provide...