1|Page
Cosmetology Florida State Board
Clinical Exam Review /Test Questions &
Certified Solutions
reference point used in haircutting-correct-answer-Parietal ridge,occipital bone ,
apex , and four corners
The three possible shapes of hair when viewed as a cross-section are round , oval ,
and-correct-answer-The shape of a cross-section of the hair can be round, oval ,
or nearly flat.
to give more body and body and weight to fine hair-correct-answer-cut blunt
to reduce tangling of the hair while rising the relaxer , use-correct-answer-always
rinse with warm water to remove all traces of the product and avoid tangling.
To test for the existence of metallic dyes in the hair, place a strand of hair in the
following solution-correct-answer-1 ounce 20 volume H202, 20 drops ammonia
,2|Page
Unless instructions say otherwise, to stop the action of a relaxer, the stylist
should-correct-answer-rinse with warm water
The use thinning shears is sometimes referred to as-correct-answer-thinning
shears can be used as a blending technique .
Use thinning or tapering shears to-correct-answer-Remove bulk
The volume of hydrogen peroxide may be reduced by diluting with-correct-
answer-Distilled Water
what is considered an average normal daily rate of hair loss due to the three
phrases of the hair growth cycle?-correct-answer-35-40
what is the degree of blunt haircut elevation ?-correct-answer-0
what is the name for chemical reaction that occurs when H2O2 is combined with
bleach or aniline derivate tint-correct-answer-oxidation
,3|Page
When applying temporary color to hair , gloves should worn to-correct-answer-
Temporary color rinses can stain , so it is best to wear gloves. Prevent staining of
the skin.
When a blow dryer use a large diameter round brush to achieve .-correct-answer-
A loose wave
When cutting hair with electric clippers , the hair should be-correct-answer-dry
when cutting the hair with a razor , the hair should be-correct-answer-damp
When giving a blunt haircut, you should begin cutting at the-correct-answer-nape
When giving a heat wave with clamps, if a client complains about too much heat
on the neck, the cosmetologist should:-correct-answer-place cotton under clamps
, 4|Page
when giving a perm the porosity of hair determines to its ability to-correct-
answer-porosity determines the ability for substances ( such as liquids) to pass
through a material ( such as cuticle of hair )
When holding shears for cutting, where is the thumb placed?-correct-answer-In
the grip of movable blade.
when performing a chemical service , to protect the client 's clothing-correct-
answer-Have the client change into a gown
when performing a tint back to natural hair color , from a lighter color , which of
the following products is recommended-correct-answer-A color filler
when performing a virgin lightening on the hair begin the application-correct-
answer-starting away from the scalp up to the ends
when performing a virgin sodium hydroxide relaxer , apply the product-correct-
answer-1/2 inch from the scalp to the ends
Cosmetology Florida State Board
Clinical Exam Review /Test Questions &
Certified Solutions
reference point used in haircutting-correct-answer-Parietal ridge,occipital bone ,
apex , and four corners
The three possible shapes of hair when viewed as a cross-section are round , oval ,
and-correct-answer-The shape of a cross-section of the hair can be round, oval ,
or nearly flat.
to give more body and body and weight to fine hair-correct-answer-cut blunt
to reduce tangling of the hair while rising the relaxer , use-correct-answer-always
rinse with warm water to remove all traces of the product and avoid tangling.
To test for the existence of metallic dyes in the hair, place a strand of hair in the
following solution-correct-answer-1 ounce 20 volume H202, 20 drops ammonia
,2|Page
Unless instructions say otherwise, to stop the action of a relaxer, the stylist
should-correct-answer-rinse with warm water
The use thinning shears is sometimes referred to as-correct-answer-thinning
shears can be used as a blending technique .
Use thinning or tapering shears to-correct-answer-Remove bulk
The volume of hydrogen peroxide may be reduced by diluting with-correct-
answer-Distilled Water
what is considered an average normal daily rate of hair loss due to the three
phrases of the hair growth cycle?-correct-answer-35-40
what is the degree of blunt haircut elevation ?-correct-answer-0
what is the name for chemical reaction that occurs when H2O2 is combined with
bleach or aniline derivate tint-correct-answer-oxidation
,3|Page
When applying temporary color to hair , gloves should worn to-correct-answer-
Temporary color rinses can stain , so it is best to wear gloves. Prevent staining of
the skin.
When a blow dryer use a large diameter round brush to achieve .-correct-answer-
A loose wave
When cutting hair with electric clippers , the hair should be-correct-answer-dry
when cutting the hair with a razor , the hair should be-correct-answer-damp
When giving a blunt haircut, you should begin cutting at the-correct-answer-nape
When giving a heat wave with clamps, if a client complains about too much heat
on the neck, the cosmetologist should:-correct-answer-place cotton under clamps
, 4|Page
when giving a perm the porosity of hair determines to its ability to-correct-
answer-porosity determines the ability for substances ( such as liquids) to pass
through a material ( such as cuticle of hair )
When holding shears for cutting, where is the thumb placed?-correct-answer-In
the grip of movable blade.
when performing a chemical service , to protect the client 's clothing-correct-
answer-Have the client change into a gown
when performing a tint back to natural hair color , from a lighter color , which of
the following products is recommended-correct-answer-A color filler
when performing a virgin lightening on the hair begin the application-correct-
answer-starting away from the scalp up to the ends
when performing a virgin sodium hydroxide relaxer , apply the product-correct-
answer-1/2 inch from the scalp to the ends
