Avionics Electronics Technician (AET) Exam with all Correc
& 100% Verified Answers |Latest Version |Already Graded A+
1. Generally, aircraft electrical wire is 600 Volts
rated at
.
80 turns and 10.7 amps
2. A transformer is required to produce
28 volts in the secondary coil. How many
turns of wire are required in the
secondary coil and what amperes are
created when thefollowing information
is known? Pri- mary Coil = 115 volts;
330
turns; 2.6 amps. properly grounded prior to use
3. Concerning electrostatic discharge
sen- sitive devices ensure all hand
tools series inductor, shunt capacitor
are .
4. LC choke-input filters are characterized
by a base number
at the input and a
across the output.
5. In scientific notation, the is the
numbering system of the reference
number.
6. the C1 capacitor is open. If an AC Voltmeter is connected
across the output of the circuit
below and shows a reading of
10 VAC, then
1/
21
, Avionics Electronics Technician (AET) Exam with all Correc
& 100% Verified Answers |Latest Version |Already Graded A+
7. When exposure to noise exceeds 85 decibels
over an eight hour period, hearing
protection is typically required.
8. An open resistor normally has extremely high resistance.
2/
21
, Avionics Electronics Technician (AET) Exam with all Correc
& 100% Verified Answers |Latest Version |Already Graded A+
9. In the monostable multivibrator on/ott switches.
shown be- low, transistors Q1 and Q2
both function as
10. What is the input of the circuit if the output (C) A = low, B = high
is high?
11. is the international symbol that rep- "I"
resents current.
12. The Xc(Capacitive Reactance) of a Decreases, increases
capacitor
as the frequency .
0.4 microfarads
13. What is the total capacitance of a
circuit with three capacitors, all of
which are in parallel with each other,
and have
capacitances of 0.25 microfarads, 0.03
micro- farads and 0.12 microfarads,
respectively?
14. The binary equivalent of 86(10) is 1010110.
15. is used to determine the from
amount of induced voltage in a to
conductor. and against
the arrowhead.
16. In a bipolar transistor schematic
symbol, electron flow is always 17. The movement of
3/
21
& 100% Verified Answers |Latest Version |Already Graded A+
1. Generally, aircraft electrical wire is 600 Volts
rated at
.
80 turns and 10.7 amps
2. A transformer is required to produce
28 volts in the secondary coil. How many
turns of wire are required in the
secondary coil and what amperes are
created when thefollowing information
is known? Pri- mary Coil = 115 volts;
330
turns; 2.6 amps. properly grounded prior to use
3. Concerning electrostatic discharge
sen- sitive devices ensure all hand
tools series inductor, shunt capacitor
are .
4. LC choke-input filters are characterized
by a base number
at the input and a
across the output.
5. In scientific notation, the is the
numbering system of the reference
number.
6. the C1 capacitor is open. If an AC Voltmeter is connected
across the output of the circuit
below and shows a reading of
10 VAC, then
1/
21
, Avionics Electronics Technician (AET) Exam with all Correc
& 100% Verified Answers |Latest Version |Already Graded A+
7. When exposure to noise exceeds 85 decibels
over an eight hour period, hearing
protection is typically required.
8. An open resistor normally has extremely high resistance.
2/
21
, Avionics Electronics Technician (AET) Exam with all Correc
& 100% Verified Answers |Latest Version |Already Graded A+
9. In the monostable multivibrator on/ott switches.
shown be- low, transistors Q1 and Q2
both function as
10. What is the input of the circuit if the output (C) A = low, B = high
is high?
11. is the international symbol that rep- "I"
resents current.
12. The Xc(Capacitive Reactance) of a Decreases, increases
capacitor
as the frequency .
0.4 microfarads
13. What is the total capacitance of a
circuit with three capacitors, all of
which are in parallel with each other,
and have
capacitances of 0.25 microfarads, 0.03
micro- farads and 0.12 microfarads,
respectively?
14. The binary equivalent of 86(10) is 1010110.
15. is used to determine the from
amount of induced voltage in a to
conductor. and against
the arrowhead.
16. In a bipolar transistor schematic
symbol, electron flow is always 17. The movement of
3/
21
