COMPLETE QUESTIONS AND CORRECT DETAILED
ANSWERS (VERIFIED ANSWERS) |ALREADY
GRADED A+||BRAND NEW VERSION!!
How would you test 4-20 mA sensor - CORRECT ANSWER- In series
The MPU - 23 card exhibits what color lights on the panel when operating
normally - CORRECT ANSWER- Green Yellow Yellow
How many digits are in a NSN - CORRECT ANSWER- 13
What cut are R/G teeth? - CORRECT ANSWER- helical
Oil fog out of R/G - CORRECT ANSWER- Faulty precipitator
Standard hoses shall be identified as Standard in Hose Log and shall be scheduled
for replacement at intervals not to exceed - CORRECT ANSWER- 8 years
,What % hydraulic failure is due to contamination? - CORRECT ANSWER- 80%
Hoses installed in the weather without an outer covering specifically designed for
service in the weather shall have a service life not to exceed - CORRECT ANSWER- 5
years
When using an ammeter to troubleshoot a system always use what - CORRECT
ANSWER- The highest scale
Small engine exhaust hose service life shall be in accordance with the hose
manufacturer recommendation or - CORRECT ANSWER- 5 years whichever is less
When is the cutter engineering report due? - CORRECT ANSWER- Jan 31
What type of engine is on a P100 - CORRECT ANSWER- Single cylinder air cooled four
stroke
How long will a P6 pump run on a tank of fuel - CORRECT ANSWER- 4 hours
What type of engine is on a P6 pump - CORRECT ANSWER- 6.5 horsepower Honda GX-
200 has engine
The most common type of media for coarse filtration is - CORRECT ANSWER- Surface
media
What is the disadvantage of a centrifugal pump - CORRECT ANSWER- Suction lift
,The shelf life for hoses and prefabricated hose assemblies shall not exceed -
CORRECT ANSWER- 10 years
As wire size increases, what happens to resistance and amperage? - CORRECT
ANSWER- Resistance down - Amperage up
What does CAN stand for? - CORRECT ANSWER- Controller Area Network
What % of working pressure do you test a temp hose - CORRECT ANSWER- 150
How does a rise in the R/O input water temp effect the output temp - CORRECT
ANSWER- Output increases
What coolant is used in a keel cooler? - CORRECT ANSWER- antifreeze
At a modernized unit, where is your boat inspection report recorded? - CORRECT
ANSWER- ALMIS
How often is the cutter engineering report conducted - CORRECT ANSWER- Yearly
Rudder stock is supported by what? - CORRECT ANSWER- bearing
, Waster ring in the sea chest is for what? - CORRECT ANSWER- prevent galvanic
corrosion
What is the acceptable leakage rate in a screw type hydraulic pump shaft seal -
CORRECT ANSWER- 50ml
If you have a bearing failure in a centrifugal pump with excessive vibration, what
is the likely cause? - CORRECT ANSWER- misalignment
What causes aeration in a hydraulic system if there are no leaks? - CORRECT
ANSWER- low fluid
You find something else is wrong with a piece of equipment already CASREPed
what should you send? - CORRECT ANSWER- Update
A thrust bearing supports what type of movement - CORRECT ANSWER- axial and
radial
What does SSS stand for in a SSS clutch? - CORRECT ANSWER- Syncro-Self-Shifting
How is tin measured in a spectrometric oil analysis? - CORRECT ANSWER- ppm
If you find 40psi in a TANB trailer tire what type of discrepancy is it? - CORRECT
ANSWER- restrictive