} Practice Questions and
Verified Answers {Grade A} 100 % Correct
A smog technician is conducting an ASM smog test on a vehicle with a standard
transmission (stick). The engine size is 3.6L. What gear should the technician first try
to conduct the test and what RPM should he keep the engine within while conducting
the test? - correct answer 2nd gear with the RPM between 1250 and 2500
How often must you calibrate the BAR-97 EIS? - correct answer Every 72 hours or
when prompted NOT AND PROMPTED OR
The emission inspection system (EIS) shows a dilution error on the screen. What is the
EIS seeing at this time? - correct answer High O2
The TAC (Thermostatic Air Control) helps heath the incoming air to the induction
system. This control is accomplished by a vacuum operated blend door in the air
cleaner snorkel. When the nine is not running (0° manifold vacuum), in what position
is the blend door? - correct answer The "Hot air mode"
Technician A states that Exhaust Gas Recirculation is a post-combustion emission
component. Technician B States that the Exhaust Gas Recirculation is a pre-
combustion emission component. Who is correct? - correct answer Technician B
, Smog Inspector BAR EXAM {Latest Update
} Practice Questions and
Verified Answers {Grade A} 100 % Correct
Technician A States that the MIL illuminates when emissions are inferred to be 1.5
times the federal test procedures standards. Technician B states the MIL may only be
used fo emission failures. Who is correct? - correct answer Both technicians
Which of the following inspection procedures is performed with the engine running?
Fuel Cap Pressure Test
Liquid Fuel Leaks Check
Oil Level Check
Visual Inspection - correct answer Liquid fuel leaked check
During an OIS inspection on a 2000MY or newer vehicle, what would be the correct
procedure to follow if the customer did not bring the registration paperwork for the
smog Check inspection? - correct answer Scan the Barcode on the vehicle itself
The Smog inspector has entered all the data into the EIS. The EIS contacts the VID
and it returns a message "No Match" how should the inspector proceed with this
smog check? - correct answer Verify the VIN and Plate number match the numbers
on the DMV paperwork, if so, complete the smog check inspection
Technician A states that inspectors are not required to perform disassembly of the
vehicle to inspect for liquid fuel leaks. Technician B states the liquid fuel leak visual