WELL DETAILED ANSWERS|LATEST
UPDATE!!!!2025/2026|GUARANTEED
What is the maximum number of 14 AWG RHH conductors which can be installed in 1/2 rigid
metal conduit? - ANSWER 4 wires
Which of the following would be an appropriate mounting height for a pull station? -
ANSWER 3.5'-48" to the actuator
What is the minimum flash rate for a visible notification device? - ANSWER 1 flash per
second
What is the minimum mounting height for audible notification devices? - ANSWER 90"
to the top of the device
What is the minimum mounting height for visible notification devices? - ANSWER Such
that the entire lens is not less then 80"
What is the formula for Ohm's Law - ANSWER Voltage=Current X Resistence
When using your mult-meter to measure, you must: - ANSWER Put your meter in
series with the circuit
Waterflow devices shall be tested with that frequency? - ANSWER Semi-annually
1
, With what frequency shall ionization smoke detectors be given a functional test? -
ANSWER Annually
What are the standby power requirements for a proprietary signaling system? -
ANSWER 24 hours in normal operation, 5 minutes in alarm
Which of the following is a type of auxiliary protective signaling system? -
ANSWER Shunt type
Remote station signaling systems are permitted to send signals to: - ANSWER A UL
listed central station
A receiver located at an unlisted monitoring facility
A fire department or communications center
Non-power limited fire alarm cable shall have an insulation rating of: - ANSWER 600V
Which of these HVAC systems would require duct detectors on supply and return? -
ANSWER 20,000 CFM HVAC system serving a single floor
15,000 CFM HVAC system serving 3 floors
20,000 CFM HVAC system serving 2 floors
According to the IBC, which of the following use Groups require visual notification? -
ANSWER Group A, E, F
Digital Alarm communicator transmitters (DACT) which use call forwarding to the DACR shall
be tested with what frequency? - ANSWER Every 4 hours
When connecting 4 wires smoke detectors to a fire alarm system, the power conductors
shall be monitored for integrity. - ANSWER True
2
UPDATE!!!!2025/2026|GUARANTEED
What is the maximum number of 14 AWG RHH conductors which can be installed in 1/2 rigid
metal conduit? - ANSWER 4 wires
Which of the following would be an appropriate mounting height for a pull station? -
ANSWER 3.5'-48" to the actuator
What is the minimum flash rate for a visible notification device? - ANSWER 1 flash per
second
What is the minimum mounting height for audible notification devices? - ANSWER 90"
to the top of the device
What is the minimum mounting height for visible notification devices? - ANSWER Such
that the entire lens is not less then 80"
What is the formula for Ohm's Law - ANSWER Voltage=Current X Resistence
When using your mult-meter to measure, you must: - ANSWER Put your meter in
series with the circuit
Waterflow devices shall be tested with that frequency? - ANSWER Semi-annually
1
, With what frequency shall ionization smoke detectors be given a functional test? -
ANSWER Annually
What are the standby power requirements for a proprietary signaling system? -
ANSWER 24 hours in normal operation, 5 minutes in alarm
Which of the following is a type of auxiliary protective signaling system? -
ANSWER Shunt type
Remote station signaling systems are permitted to send signals to: - ANSWER A UL
listed central station
A receiver located at an unlisted monitoring facility
A fire department or communications center
Non-power limited fire alarm cable shall have an insulation rating of: - ANSWER 600V
Which of these HVAC systems would require duct detectors on supply and return? -
ANSWER 20,000 CFM HVAC system serving a single floor
15,000 CFM HVAC system serving 3 floors
20,000 CFM HVAC system serving 2 floors
According to the IBC, which of the following use Groups require visual notification? -
ANSWER Group A, E, F
Digital Alarm communicator transmitters (DACT) which use call forwarding to the DACR shall
be tested with what frequency? - ANSWER Every 4 hours
When connecting 4 wires smoke detectors to a fire alarm system, the power conductors
shall be monitored for integrity. - ANSWER True
2
