TCFP INSPECTOR'S CLASS ACTUAL
QUESTIONS AND ANSWERS
Which duty is not the responsibility of a level I Inspector?
A) Handle citizen complaints related to fire and life safety.
B) Perform plans reviews.
C) Interpret and apply adopted codes and standards.
D) Determine occupancy loads for single-use buildings. - ANSWER-Perform
plans reviews.
Most of the consensus standards that relate to fire and life safety are
developed by the following organizations except:
ASTM International,
National Fire Protection Assoc.,
American National Standards Institute,
Underwriters Laboratories - ANSWER-American National Standards Institute
Regarding Commercial Kitchen Hood Systems, pipe penetrations of the
exhaust hood require what?
a. Minimum 18 inch clearance to combustible materials
b. Printed manufacturer guidelines of spacing on the pipe itself
c. Gas shut off valve and electrical shunt accessibility
d. A liquid tight continuous external weld - ANSWER-A liquid tight continuous
external weld
A independent, non-profit organization that tests products for their intended
use and certifies them as safe describes:
A) ASTM International
B) American National Standards Institute
C) Underwriters Laboratories Inc.
,D) Standards Council of Canada - ANSWER-Underwriters Laboratories Inc.
Which is not one of the three general types of drawings used to show
structure, facility, or site information?
A. Plot plan
B. Aerial view
C. Floor plan
D. Elevation view - ANSWER-Aerial view
Structural lumber has a moisture content of ___________% or less.
25%
19%
15%
12% - ANSWER-19%
Which of the following occupancies does not fall under state and local
regulations?
A). Day care
B). Jail
C). Post office
D). Medical facility - ANSWER-Post office
The typical life cycle of a model code edition is ___ years.
a. 5-7
b. 2-3
c. 7-10
d. 3-5 - ANSWER-3-5
For Dry systems exceeding 500 gallons, there must be a quick opening
device installed unless water is delivered to the system test connection
within a specific time frame. What is this time frame?
A. 30 seconds
B. 60 seconds
, C. Not more than 30 seconds
D. Not more than 60 seconds - ANSWER-Not more than 60 seconds
Which of the following is an inspector not authorized to do?
A. Issue a summons.
B. Issue citations.
C. File complaints for code violations.
D. Prosecute an offender in a court of law. - ANSWER-Prosecute an offender in
a court of law.
While exercising enforcement power, it is essential that the inspector ensure
that the rights of the accused are protected and that ______________ is
practiced.
A.) Worksite Safety
B.) Due Process
C.) Customer Appreciation
D.) Strict Compliance - ANSWER-Due Process
T or F Federal and some state/provincial-owned buildings located within the
local jurisdiction are required to comply with local codes. - ANSWER-False
An educational occupancy is any building or portion of a building that is used
for the purpose of education of ___ or more persons from preschool through
the 12th grade.
a. 6
b. 5
c. 10
d. 2 - ANSWER-6
The term is used to describe a set of requirements similar to a standard. A
consensus organization, such as NFPA, develop these codes that contain
agreed-upon requirements for such areas as fire and life safety designs and
installations.
A. Performance Code
B. Prescriptive Code
QUESTIONS AND ANSWERS
Which duty is not the responsibility of a level I Inspector?
A) Handle citizen complaints related to fire and life safety.
B) Perform plans reviews.
C) Interpret and apply adopted codes and standards.
D) Determine occupancy loads for single-use buildings. - ANSWER-Perform
plans reviews.
Most of the consensus standards that relate to fire and life safety are
developed by the following organizations except:
ASTM International,
National Fire Protection Assoc.,
American National Standards Institute,
Underwriters Laboratories - ANSWER-American National Standards Institute
Regarding Commercial Kitchen Hood Systems, pipe penetrations of the
exhaust hood require what?
a. Minimum 18 inch clearance to combustible materials
b. Printed manufacturer guidelines of spacing on the pipe itself
c. Gas shut off valve and electrical shunt accessibility
d. A liquid tight continuous external weld - ANSWER-A liquid tight continuous
external weld
A independent, non-profit organization that tests products for their intended
use and certifies them as safe describes:
A) ASTM International
B) American National Standards Institute
C) Underwriters Laboratories Inc.
,D) Standards Council of Canada - ANSWER-Underwriters Laboratories Inc.
Which is not one of the three general types of drawings used to show
structure, facility, or site information?
A. Plot plan
B. Aerial view
C. Floor plan
D. Elevation view - ANSWER-Aerial view
Structural lumber has a moisture content of ___________% or less.
25%
19%
15%
12% - ANSWER-19%
Which of the following occupancies does not fall under state and local
regulations?
A). Day care
B). Jail
C). Post office
D). Medical facility - ANSWER-Post office
The typical life cycle of a model code edition is ___ years.
a. 5-7
b. 2-3
c. 7-10
d. 3-5 - ANSWER-3-5
For Dry systems exceeding 500 gallons, there must be a quick opening
device installed unless water is delivered to the system test connection
within a specific time frame. What is this time frame?
A. 30 seconds
B. 60 seconds
, C. Not more than 30 seconds
D. Not more than 60 seconds - ANSWER-Not more than 60 seconds
Which of the following is an inspector not authorized to do?
A. Issue a summons.
B. Issue citations.
C. File complaints for code violations.
D. Prosecute an offender in a court of law. - ANSWER-Prosecute an offender in
a court of law.
While exercising enforcement power, it is essential that the inspector ensure
that the rights of the accused are protected and that ______________ is
practiced.
A.) Worksite Safety
B.) Due Process
C.) Customer Appreciation
D.) Strict Compliance - ANSWER-Due Process
T or F Federal and some state/provincial-owned buildings located within the
local jurisdiction are required to comply with local codes. - ANSWER-False
An educational occupancy is any building or portion of a building that is used
for the purpose of education of ___ or more persons from preschool through
the 12th grade.
a. 6
b. 5
c. 10
d. 2 - ANSWER-6
The term is used to describe a set of requirements similar to a standard. A
consensus organization, such as NFPA, develop these codes that contain
agreed-upon requirements for such areas as fire and life safety designs and
installations.
A. Performance Code
B. Prescriptive Code
