Suspension and Steering Practice Test
Exam Question & Answers ( Latest
2025)
A vehicle has excessive body sway while cornering. Which
of these is most likely to cause this condition.
A. A binding ball joint.
B. A warn idler arm.
C. Warn control arm bushings.
D. Warn stabilizer bar bushings - CORRECT ANSWERS
✔✔D. Warn stabilizer bar bushings
A vehicle with variable assist steering feels loose only at
highway speeds. Technician A says this is likely caused by
the vehicle speed sensor. Technician B says this could be
caused by reduced pressure to the steering gear at high
speeds.
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - CORRECT ANSWERS ✔✔A.
Technician A only
. A vehicle with a ribbed belt makes a chirping noise when
starting. Technician A says to check the belt with a belt
wear gauge. Technician B says proper belt deflection is
1/2 inch per foot of belt span. Who is correct?
,Suspension and Steering Practice Test
Exam Question & Answers ( Latest
2025)
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - CORRECT ANSWERS ✔✔C. Both A
and B
Technician A says after tightening the castle nut on a
tapered ball joint to loosen it to align and install the
cotter pin. Technician B says a binding ball joint will cause
memory steer. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - CORRECT ANSWERS ✔✔B.
Technician B only
On cold mornings the warning lamp on a vehicle with a
tire pressure monitoring system TPMS stays illuminated
for several minutes before it goes out. Which of these are
most likely the cause of this condition.
A. Clogged TPMS sensor.
B. Worn tread on one of the tires.
, Suspension and Steering Practice Test
Exam Question & Answers ( Latest
2025)
C. TPMS initialization.
D. Low tire pressure - CORRECT ANSWERS ✔✔D.
Low tire pressure
A front wheel drive vehicle has a pull and is being
checked for alignment angles. Technician A says loose
engine cradle bolts have no affect on a vehicle's steering
system. Technician B says if the engine cradle is not
centered before tightening the bolts the wheel alignment
angles will be affected. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - CORRECT ANSWERS ✔✔B.
Technician B only
Two technicians are discussing an electronic air
suspension system. Technician A says the suspension
switch must be turned off before lifting the vehicle.
Technician B says soapy water is used to check these
systems for leaks. Who is correct?
A. Technician A
B. Technician B
Exam Question & Answers ( Latest
2025)
A vehicle has excessive body sway while cornering. Which
of these is most likely to cause this condition.
A. A binding ball joint.
B. A warn idler arm.
C. Warn control arm bushings.
D. Warn stabilizer bar bushings - CORRECT ANSWERS
✔✔D. Warn stabilizer bar bushings
A vehicle with variable assist steering feels loose only at
highway speeds. Technician A says this is likely caused by
the vehicle speed sensor. Technician B says this could be
caused by reduced pressure to the steering gear at high
speeds.
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - CORRECT ANSWERS ✔✔A.
Technician A only
. A vehicle with a ribbed belt makes a chirping noise when
starting. Technician A says to check the belt with a belt
wear gauge. Technician B says proper belt deflection is
1/2 inch per foot of belt span. Who is correct?
,Suspension and Steering Practice Test
Exam Question & Answers ( Latest
2025)
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - CORRECT ANSWERS ✔✔C. Both A
and B
Technician A says after tightening the castle nut on a
tapered ball joint to loosen it to align and install the
cotter pin. Technician B says a binding ball joint will cause
memory steer. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - CORRECT ANSWERS ✔✔B.
Technician B only
On cold mornings the warning lamp on a vehicle with a
tire pressure monitoring system TPMS stays illuminated
for several minutes before it goes out. Which of these are
most likely the cause of this condition.
A. Clogged TPMS sensor.
B. Worn tread on one of the tires.
, Suspension and Steering Practice Test
Exam Question & Answers ( Latest
2025)
C. TPMS initialization.
D. Low tire pressure - CORRECT ANSWERS ✔✔D.
Low tire pressure
A front wheel drive vehicle has a pull and is being
checked for alignment angles. Technician A says loose
engine cradle bolts have no affect on a vehicle's steering
system. Technician B says if the engine cradle is not
centered before tightening the bolts the wheel alignment
angles will be affected. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - CORRECT ANSWERS ✔✔B.
Technician B only
Two technicians are discussing an electronic air
suspension system. Technician A says the suspension
switch must be turned off before lifting the vehicle.
Technician B says soapy water is used to check these
systems for leaks. Who is correct?
A. Technician A
B. Technician B
