Rhode Island Journeyman Plumber EXAM TEST WITH
LATEST UPDATED (QUESTIONS AND ANSWERS)
already passed!!
State of Rhode Island Plumbing Code is known as: - (answers)Plumbing Code
Regulation SBC-3
Water Services Shall Be Installed Not Less Than: - (answers)4' 6" Below Grade
Piping installed in exterior walls or areas subject to freezing must: -
(answers)Insulated/Heated or Both
Building Sewers connected to a public sewer shall have a minimum coverage of: -
(answers)36" Below Grade
A safe waste pan shall be installed - (answers)Under a water heater 6 gallons or
greater that is elevated
A safe waste pan shall be at least - (answers)2" deep with 2" clearance around
heater
Water service piping and building drain/sewer shall be separated by: -
(answers)10' undisturbed compacted earth
Water service separation distance is not required if: - (answers)Water line is
installed minimum 12" above sewer line at highest point
,Distance for a septic tank/sewer to a private water supply(well) is: - (answers)50'
Where frost closure is common an increase in vent size shall take place: -
(answers)6"below the roof with an approved fitting
High Hazard flood zone is: - (answers)"V" zone (subject to wave heights in excess
of 3')
Lead free pipe and fittings contain less than: - (answers)8.0% Lead
Hot water is water at temperature greater than or equal to: - (answers)110
degrees
Lead free solder and flux contain no more than - (answers)0.2% Lead
Strainer plates on drain lines for rodent proofing must have openings: -
(answers)0.5 inches
Sleeves for pipes passing through foundation walls or under footings shall be: -
(answers)Two pipe size greater than the pipe passing through it
Travel distance to toilet facilities in merchantile/occupancies are: - (answers)500'
, Travel distance to toilet facilities in covered malls are: - (answers)300'
Water closets, bidets or lavatories shall have a clearance from center of fixture to
wall of: - (answers)15"
The required clearance from front of fixture to a wall, door or other fixture is: -
(answers)21"
Minimum size floor drains for public laundries or central washing facilities is: -
(answers)3"
Shower waste outlets shall be minimum of: - (answers)1 1/2"
Minimum size removable strainer for shower compartments are: - (answers)3"
Minimum size floor drain strainer opening is: - (answers).25 inches
Sheet lead shall not weigh less than: - (answers)4 pounds per square foot
Sheet copper shall not weigh less than: - (answers)12 ounces per square foot
LATEST UPDATED (QUESTIONS AND ANSWERS)
already passed!!
State of Rhode Island Plumbing Code is known as: - (answers)Plumbing Code
Regulation SBC-3
Water Services Shall Be Installed Not Less Than: - (answers)4' 6" Below Grade
Piping installed in exterior walls or areas subject to freezing must: -
(answers)Insulated/Heated or Both
Building Sewers connected to a public sewer shall have a minimum coverage of: -
(answers)36" Below Grade
A safe waste pan shall be installed - (answers)Under a water heater 6 gallons or
greater that is elevated
A safe waste pan shall be at least - (answers)2" deep with 2" clearance around
heater
Water service piping and building drain/sewer shall be separated by: -
(answers)10' undisturbed compacted earth
Water service separation distance is not required if: - (answers)Water line is
installed minimum 12" above sewer line at highest point
,Distance for a septic tank/sewer to a private water supply(well) is: - (answers)50'
Where frost closure is common an increase in vent size shall take place: -
(answers)6"below the roof with an approved fitting
High Hazard flood zone is: - (answers)"V" zone (subject to wave heights in excess
of 3')
Lead free pipe and fittings contain less than: - (answers)8.0% Lead
Hot water is water at temperature greater than or equal to: - (answers)110
degrees
Lead free solder and flux contain no more than - (answers)0.2% Lead
Strainer plates on drain lines for rodent proofing must have openings: -
(answers)0.5 inches
Sleeves for pipes passing through foundation walls or under footings shall be: -
(answers)Two pipe size greater than the pipe passing through it
Travel distance to toilet facilities in merchantile/occupancies are: - (answers)500'
, Travel distance to toilet facilities in covered malls are: - (answers)300'
Water closets, bidets or lavatories shall have a clearance from center of fixture to
wall of: - (answers)15"
The required clearance from front of fixture to a wall, door or other fixture is: -
(answers)21"
Minimum size floor drains for public laundries or central washing facilities is: -
(answers)3"
Shower waste outlets shall be minimum of: - (answers)1 1/2"
Minimum size removable strainer for shower compartments are: - (answers)3"
Minimum size floor drain strainer opening is: - (answers).25 inches
Sheet lead shall not weigh less than: - (answers)4 pounds per square foot
Sheet copper shall not weigh less than: - (answers)12 ounces per square foot
