CWEA MECHANICAL TECH GRADE 1
EXAM 2025 QUESTIONS AND ANSWERS
A partial flume is used to measure: - ANS Liquid flows in an open channel
Chisels and punches are dangerous when their striking faces have become? -
ANS Mushroomed
A chuck key should be? - ANS Attached to the drill press by short chain or cable
When replacing a coupling on a pump, it is not important to check the alignment of two shafts -
ANS False
A bimetallic strip would be used in a - ANS Thermostat
A flux is applied during brazing to - ANS Prevent formation of oxide film in the are of joint
A wooden ladder painted osha yellow is a safety hazard because - ANS Paint may conceal
cracks in rails and rungs
In a worn gear speed reducer the input and output shafts are in a straight line with each other -
ANS False
Dry air should be used to pressure test a cl2 piping system - ANS True
1 Copyright ©2025 SIRJOEL ALL RIGHTS RESERVED
EXAM 2025 QUESTIONS AND ANSWERS
A partial flume is used to measure: - ANS Liquid flows in an open channel
Chisels and punches are dangerous when their striking faces have become? -
ANS Mushroomed
A chuck key should be? - ANS Attached to the drill press by short chain or cable
When replacing a coupling on a pump, it is not important to check the alignment of two shafts -
ANS False
A bimetallic strip would be used in a - ANS Thermostat
A flux is applied during brazing to - ANS Prevent formation of oxide film in the are of joint
A wooden ladder painted osha yellow is a safety hazard because - ANS Paint may conceal
cracks in rails and rungs
In a worn gear speed reducer the input and output shafts are in a straight line with each other -
ANS False
Dry air should be used to pressure test a cl2 piping system - ANS True
1 Copyright ©2025 SIRJOEL ALL RIGHTS RESERVED
