Electronic Engineering Exam Study Guide Questions And Answers Verified 100% Correct

Electronic Engineering Exam Study Guide Questions And Answers Verified 100% Correct Ball bearings have the least - ANSWER Surface to surface, metal to metal contact exploiting the low viscosity of the layer of fluid Viscosity will go down - ANSWER decrease with increase in temperature EP oil lubrication can be - ANSWER Corrosive under certain conditions EP greases are used for - ANSWER High temperatures, low speed operations due to high pressure or shock loading Rosin is commonly used in - ANSWER Electronic and electronic soldering. Pipe fitting with threads on inside and outside is - ANSWER A bushing Cavitations can - ANSWER Damage a pump A faulty high Limit Switch can cause a - ANSWER Pressure relief valve on a boiler to trip The speed that a RPM can safely run on a grinder - ANSWER Depends upon the speed the wheel is rated forj Small bubbles that are formed in liquid and implode violently and create low head pressure - ANSWER Cavitations Hydraulic pressure exiting the pump is greater than that fluid exiting the tank - ANSWER Due to back flow prevention Advantages of brazing over welding are - ANSWER Lower flame temperatures Flux removes - ANSWER Oxides and prevents oxidation during brazing A series circuit - ANSWER Has only one path to current to flow An amperage meter is used to - ANSWER Measure current in a circuit On an ohm meter, a reading that stays on zero indicates - ANSWER A shorted capacitor On an ohm meter, a reading that reads an infinite reading - ANSWER Indicates the capacitor didn't charge Kinetic energy - ANSWER the energy an object has due to its motion Potential energy - ANSWER is stored energy When a device or wire is shorted - ANSWER There will be high current and low resistance The purpose of tinning a soldering iron or component - ANSWER Is to remove oxidation You peen a weld to - ANSWER Remove slag as you weld