In addition to providing electrical energy, the lead-acid battery can also be a source
of fire in the form of what type of gas? Section 27.5.3.2
A. Oxygen
B. Carbon Dioxide
C. Hydrogen
D. Other acidic gasses
Give this one a try later!
, C. Hydrogen
What is the melting temperature of die cast zinc which is used to construct the typical
ignition lock cylinder?
a. 240-500*F
b. 560-750*F
c. 800-1200*F
d. 1250-1500*F
Give this one a try later!
b. 560-750*F
Melted metals in a vehicle do not indicate which of the following?
A. Fluid line failure
B. Electrical Failure
C. Ignitable liquid as an accelerant
D. None of the above
Give this one a try later!
C. Ignitable liquid as an accelerant
The pressure from the mechanical fuel pump to the carburetor system is typically in
the rate of _____ PSI.
a. 3-5
, b. 10-20
c. 32
d. 32-70
Give this one a try later!
a. 3-5
The most common open flame in a carburated vehicle fire is:
a. lighted match
b. pilot flames or operating burners
c. catalytic converter
d. a backfire through the carburator
Give this one a try later!
d. a backfire through the carburetor (bad question)
Federal Motor Vehicle Safety Standard 301 is intended specifically to reduce the fire
hazard resulting from ____________.
a. transmission fluid
b. motor oil
c. brake fluids
d. motor fuel
Give this one a try later!
d. motor fuel
of fire in the form of what type of gas? Section 27.5.3.2
A. Oxygen
B. Carbon Dioxide
C. Hydrogen
D. Other acidic gasses
Give this one a try later!
, C. Hydrogen
What is the melting temperature of die cast zinc which is used to construct the typical
ignition lock cylinder?
a. 240-500*F
b. 560-750*F
c. 800-1200*F
d. 1250-1500*F
Give this one a try later!
b. 560-750*F
Melted metals in a vehicle do not indicate which of the following?
A. Fluid line failure
B. Electrical Failure
C. Ignitable liquid as an accelerant
D. None of the above
Give this one a try later!
C. Ignitable liquid as an accelerant
The pressure from the mechanical fuel pump to the carburetor system is typically in
the rate of _____ PSI.
a. 3-5
, b. 10-20
c. 32
d. 32-70
Give this one a try later!
a. 3-5
The most common open flame in a carburated vehicle fire is:
a. lighted match
b. pilot flames or operating burners
c. catalytic converter
d. a backfire through the carburator
Give this one a try later!
d. a backfire through the carburetor (bad question)
Federal Motor Vehicle Safety Standard 301 is intended specifically to reduce the fire
hazard resulting from ____________.
a. transmission fluid
b. motor oil
c. brake fluids
d. motor fuel
Give this one a try later!
d. motor fuel
