complete solution
Technician A says that a Hydraulic Booster is usually repaired rather than
replaced. Technician B says that a Hydraulic Booster is usually replaced
rather than repaired. Who is correct? - correct answer ✔B only
In a normally operating brake system, the Master Cylinder secondary piston is
activated by ______________. - correct answer ✔fluid pressure between the
primary and secondary piston
What are some advantages of disc brakes over drum brakes? - correct
answer ✔Both are correct.
On vehicles with rear drum brakes and front disc brakes, the Metering Valve
ensures that drum brakes receive hydraulic pressure _____________. -
correct answer ✔slightly before the disc brakes
If a two square inch Master Cylinder piston moves one inch during braking,
how far will it move a four square inch Caliper piston? - correct answer ✔1/2
inch
Front Wheel Drive vehicles typically use ____________. - correct answer
✔Diagonally Split brake systems
Combination Valves incorporate ___________. - correct answer ✔all of the
above
, Technician A says that the brake lining material should be at least 1/16 inch
above the rivets. Technician B says that the brake lining material should be
1/64 inch above the rivets. Who is correct? - correct answer ✔A only
On late-model vehicles, drum brakes might be found on ___________. -
correct answer ✔Rear wheels
A micrometer is used to measure ___________. - correct answer ✔Rotor
Thickness Variation
In a drum brake system, the rotational action of the brake shoes activates the
self-adjuster linkage when the brakes are applied and the vehicle is - correct
answer ✔in reverse
Read this English Micrometer. - correct answer ✔.1862 inches
What percentage of the braking force comes from the rear brakes in a typical
Front Wheel Drive vehicle? - correct answer ✔30
A Drum-in-Hat Parking Brake system uses a small drum brake incorporated
into the: - correct answer ✔Rear Rotor
Brake Warning lights are what color(s)? - correct answer ✔Red for service
brakes and Yellow for ABS
Technician A says that a Brake Rotor that is at, or above, the discard
specification can be reused if not sanded or refinished. Technician B says that
a Brake Rotor that is above the Minimum Refinish Specification must be
refinished to the refinish specification before it can be reinstalled. Which is
correct? - correct answer ✔A only