SOLID EDGE ASSOCIATE LEVEL
EXAM STUDY GUIDE QUESTIONS
WITH ALL CORRECT ANSWERS!!
1 of 50
Definition
Mate
Give this one a try later!
What assembly relationship is
used to "glue" two faces Assemble
together? (Like a lid on a box)
, Angle Insert
Don't know?
2 of 50
Term
Which if the following is not a method to unlock the sketch
plane?
Give this one a try later!
Click escape to unlock To add a gap between faces
the plane that are currently mated
together,
To To revolve a selected region into
create the solid from the sketch,
a
round part in synchronous mode,
Don't know?
3 of 50
Term
When dragging Face #1 after selecting the arrow, which
Design
Intent relationships will be found and maintained to move
faces 2 through 6 as shown in 1 move.
,Give this one a try later!
, Select a face, press the CTRL key
Base Reference Plane and drag with the left mouse
button
Horizontal/Vertical Symmetry and Coplanar
Don't know?
4 of 50
Definition
click once for a start point and click once for an endpoint
Give this one a try later!
press and hold to draw a rectangle To sketch a line, you must...
double-click to create a circle drag the mouse to create a curve
Don't know?
5 of 50
Definition
STL
Give this one a try later!
EXAM STUDY GUIDE QUESTIONS
WITH ALL CORRECT ANSWERS!!
1 of 50
Definition
Mate
Give this one a try later!
What assembly relationship is
used to "glue" two faces Assemble
together? (Like a lid on a box)
, Angle Insert
Don't know?
2 of 50
Term
Which if the following is not a method to unlock the sketch
plane?
Give this one a try later!
Click escape to unlock To add a gap between faces
the plane that are currently mated
together,
To To revolve a selected region into
create the solid from the sketch,
a
round part in synchronous mode,
Don't know?
3 of 50
Term
When dragging Face #1 after selecting the arrow, which
Design
Intent relationships will be found and maintained to move
faces 2 through 6 as shown in 1 move.
,Give this one a try later!
, Select a face, press the CTRL key
Base Reference Plane and drag with the left mouse
button
Horizontal/Vertical Symmetry and Coplanar
Don't know?
4 of 50
Definition
click once for a start point and click once for an endpoint
Give this one a try later!
press and hold to draw a rectangle To sketch a line, you must...
double-click to create a circle drag the mouse to create a curve
Don't know?
5 of 50
Definition
STL
Give this one a try later!
