A customer complains that the steering lacks power assist all the time. Tech a says that the power
steering pump drive belt could be slipping or loose. Tech b says that worn outer tie rod ends could be
the cause. Who is correct? - Correct Answers Tech A
A front wheel drive vehicle pulls towards the right during hard acceleration. The most likely cause is? -
Correct Answers Normal torque steer
When replacing a rubber-bonded socket the rod end, the tech should be sure to? - Correct Answers
Install and tighten the replacement with the front wheels in the straight ahead position
Whenever installing a tire on a rim, do not exceed - Correct Answers 40psi
Two technicians are discussing mounting a tire on a wheel. Tech a says that for best balance, the tire
should be match mounted. Tech b says that silicone spray should be used to lubricants the tire bend.
Which is correct? - Correct Answers Tech A
Technician A says that radial tires should only be rotated front to rear, never side to side. Tech b says
that vehicle manufacturers usually recommend radial tires should be rotated using the modified x
method. Which is correct? - Correct Answers Tech b
For a tire that has excessive radial runout, tech a says that it should be broken down on a tire changing
machine and then rotated 180 degrees on the wheel and retested. Tech b says that the tire should be
replaced. Which tech is correct? - Correct Answers Tech a
Technician a says that overloading a vehicle can cause damage to the wheel bearings. Tech b says that
tappered roller bearings used on a non drive wheel should be adjusted hand tight only after seating.
Which tech is correct? - Correct Answers Both
Defective wheel bearings usually sound like a? - Correct Answers Growl, rumble, snow tires
A defective outer CV joint will usually make a clicking noise when? - Correct Answers While turning and
moving
steering pump drive belt could be slipping or loose. Tech b says that worn outer tie rod ends could be
the cause. Who is correct? - Correct Answers Tech A
A front wheel drive vehicle pulls towards the right during hard acceleration. The most likely cause is? -
Correct Answers Normal torque steer
When replacing a rubber-bonded socket the rod end, the tech should be sure to? - Correct Answers
Install and tighten the replacement with the front wheels in the straight ahead position
Whenever installing a tire on a rim, do not exceed - Correct Answers 40psi
Two technicians are discussing mounting a tire on a wheel. Tech a says that for best balance, the tire
should be match mounted. Tech b says that silicone spray should be used to lubricants the tire bend.
Which is correct? - Correct Answers Tech A
Technician A says that radial tires should only be rotated front to rear, never side to side. Tech b says
that vehicle manufacturers usually recommend radial tires should be rotated using the modified x
method. Which is correct? - Correct Answers Tech b
For a tire that has excessive radial runout, tech a says that it should be broken down on a tire changing
machine and then rotated 180 degrees on the wheel and retested. Tech b says that the tire should be
replaced. Which tech is correct? - Correct Answers Tech a
Technician a says that overloading a vehicle can cause damage to the wheel bearings. Tech b says that
tappered roller bearings used on a non drive wheel should be adjusted hand tight only after seating.
Which tech is correct? - Correct Answers Both
Defective wheel bearings usually sound like a? - Correct Answers Growl, rumble, snow tires
A defective outer CV joint will usually make a clicking noise when? - Correct Answers While turning and
moving
