©BRIGHSTARS 2024/2025 ALL RIGHTS RESERVED.
SENSE LEVEL 1: Mod 3 Drawing and
Welding Symbol Interpretation Exam
Questions And Answers 100% Pass.
1. The primary element of any welding symbol is referred to as the______. - Answer✔Reference
Line
2. Information appearing below the reference line refers to the_____. - Answer✔Arrow Side
3. The term ______ refers to the center-to-center spacing of an intermittent fillet weld. -
Answer✔Pitch
4. Which of the following is NOT considered a type of weld joint? - Answer✔Fillet
5. The weld joint formed when two parallel members overlap each other is called a _______
joint. - Answer✔Lap
6. In a single V-groove, the sloped surfaces on which the weld metal is applied are called -
Answer✔Groove Faces
7. A weld applied to the other side of a joint before the groove weld is started is called a ______.
- Answer✔Backing Weld
8. The finished surface (cover pass) of a weld is referred to as the______. - Answer✔Weld Face
9. In a completed weld, the junction between the surface of a weld and the base metal is called
the _______. - Answer✔Toe
10. The height of the weld above the base metal in a groove weld is called the _____. -
Answer✔Weld Reinforcement
11. Information appearing above the reference line refers to the _____. - Answer✔other side
12. The graphic representation of a weld to be preformed is called a _____. - Answer✔Weld
Symbol
13. A right-angle triangle attached to either side of the reference line indicates a _______. -
Answer✔Fillet Weld
14. Information that appears to the left of the weld symbol refers to the _____. - Answer✔Weld
Size
1|Page
SENSE LEVEL 1: Mod 3 Drawing and
Welding Symbol Interpretation Exam
Questions And Answers 100% Pass.
1. The primary element of any welding symbol is referred to as the______. - Answer✔Reference
Line
2. Information appearing below the reference line refers to the_____. - Answer✔Arrow Side
3. The term ______ refers to the center-to-center spacing of an intermittent fillet weld. -
Answer✔Pitch
4. Which of the following is NOT considered a type of weld joint? - Answer✔Fillet
5. The weld joint formed when two parallel members overlap each other is called a _______
joint. - Answer✔Lap
6. In a single V-groove, the sloped surfaces on which the weld metal is applied are called -
Answer✔Groove Faces
7. A weld applied to the other side of a joint before the groove weld is started is called a ______.
- Answer✔Backing Weld
8. The finished surface (cover pass) of a weld is referred to as the______. - Answer✔Weld Face
9. In a completed weld, the junction between the surface of a weld and the base metal is called
the _______. - Answer✔Toe
10. The height of the weld above the base metal in a groove weld is called the _____. -
Answer✔Weld Reinforcement
11. Information appearing above the reference line refers to the _____. - Answer✔other side
12. The graphic representation of a weld to be preformed is called a _____. - Answer✔Weld
Symbol
13. A right-angle triangle attached to either side of the reference line indicates a _______. -
Answer✔Fillet Weld
14. Information that appears to the left of the weld symbol refers to the _____. - Answer✔Weld
Size
1|Page
