©BRIGHSTARS 2024/2025 ALL RIGHTS RESERVED.
Module 3 Drawing and Welding symbol
Interpretation Exam Questions And Answers
100% Pass.
Information that appears to the left of the weld symbol refers to the__________. - Answer✔weld
size
A right-angle triangle attached to either side of the reference line indicates a_________. -
Answer✔Fillet weld
The graphic representation of a weld to be performed is called a________. - Answer✔weld
symbol
5 - Answer✔Which of the welding symbols in figure 10 represents an intermittent fillet?
Information appearing above the reference line refers to the__________. - Answer✔other side
The weld joint formed when two parallel members overlap each other is called a_______joint. -
Answer✔lap
Flare V-Groove - Answer✔The weld symbol depicts what type of joint?
Information that appears to the right of the weld symbol refers to the_________. -
Answer✔length of weld
2 inch - Answer✔The length of the other side weld in figure 6 is________.
The weld all around symbol is indicated by a _________ at the junction of the reference line and
the arrow. - Answer✔circle
1 inch - Answer✔The size of the arrow side weld in figure 6 is________.
4 inch - Answer✔The pitch of the other side weld in figure 6 is
none of the above - Answer✔Which of the welding symbols in figure 10 represents a groove
weld with melt through?
A weld applied to the other side of a joint before a groove weld is started is called a_________. -
Answer✔backing weld
joint penetration and weld size. - Answer✔The dimension C in figure 9 identifies
1|Page
Module 3 Drawing and Welding symbol
Interpretation Exam Questions And Answers
100% Pass.
Information that appears to the left of the weld symbol refers to the__________. - Answer✔weld
size
A right-angle triangle attached to either side of the reference line indicates a_________. -
Answer✔Fillet weld
The graphic representation of a weld to be performed is called a________. - Answer✔weld
symbol
5 - Answer✔Which of the welding symbols in figure 10 represents an intermittent fillet?
Information appearing above the reference line refers to the__________. - Answer✔other side
The weld joint formed when two parallel members overlap each other is called a_______joint. -
Answer✔lap
Flare V-Groove - Answer✔The weld symbol depicts what type of joint?
Information that appears to the right of the weld symbol refers to the_________. -
Answer✔length of weld
2 inch - Answer✔The length of the other side weld in figure 6 is________.
The weld all around symbol is indicated by a _________ at the junction of the reference line and
the arrow. - Answer✔circle
1 inch - Answer✔The size of the arrow side weld in figure 6 is________.
4 inch - Answer✔The pitch of the other side weld in figure 6 is
none of the above - Answer✔Which of the welding symbols in figure 10 represents a groove
weld with melt through?
A weld applied to the other side of a joint before a groove weld is started is called a_________. -
Answer✔backing weld
joint penetration and weld size. - Answer✔The dimension C in figure 9 identifies
1|Page
