©THEBRIGHT EXAM SOLUTIONS
10/30/2024 11:32 PM
Telecom Tower Technician 1 Exam
Questions And Answers 100% Pass
The basket slings on a gin pole perform what function? - answer✔Support part of the weight
and vertical forces
What is the minimum force that a work positioning system anchorage must be able to
withstand? - answer✔2 times the arresting force or 3,000 lbs
What term identifies a monopole component? - answer✔Base flange
All antennas are presumed active - answer✔True
When using bolts or u-bolts with a slotted hole present, what order are the components
installed? - answer✔Flat washer, lock washer, then nut
If you have a 16 ft ladder leaning against a building wall, how many feet from the wall does the
base need to be to provide the correct slope? - answer✔4 ft
For structural loading purposes the basket and bridle slings shall always be attached where? -
answer✔At a panel point around the leg
A hoist operator will respond to a stop signal from whom? - answer✔Any source
When calculating a fall distance using a 6 foot energy absorber, what is the maximum pull out
distance? - answer✔4 feet
How often shall all gin poles have a documented job inspection? - answer✔Daily
What do the letters LOTO stand for? - answer✔Lockout Tagout
What does a tag person do? - answer✔Applied pressure on the tag rope to controls the load
A capstan hoist is used on job sites for what purpose? - answer✔To raise and lower loads
, ©THEBRIGHT EXAM SOLUTIONS
10/30/2024 11:32 PM
When operating a Capstan Hoist, or tagging the load on the Capstan, it is important to wear
what? - answer✔Gloves
What does a Ground Fault Circuit Interrupter (GFCI) do? - answer✔Shuts off flow of electricity,
senses a short circuit, and prevents electricution
Which of the following is not a component of the gross load? - answer✔Tag force
What motion indicates retract the boom - answer✔Both fists in front of your body with your
thumbs pointed towards each other
What is the heel block used for? - answer✔To change the direction of the load, jump or tag line
from horizontal to vertical
An overhaul ball provides what function in the operations? - answer✔Provides weight allowing
the load line to treturn the ground
If the operator and signal person cannot see each other, what other way can they
communicate? - answer✔Radios
The three main components that make up a fall arrest system are - answer✔Anchorage, Full
body Harness, and connectors
What type of antenna is used to transmit signal from tower to tower? - answer✔Microwave
dish
For all power lines rated 50kv, the minimum clearance between the lines and any part of the
crane or load shall be - answer✔20 feet
All cranes must have a posted load chat visible from the operators station? - answer✔True
How often must a fire extinguisher be inspected by a qualified person? - answer✔Annually
What is a crown block? - answer✔An upper sheave assembly on top of a structure
When using a fall restraint system, what is the minimum anchorage allowed? - answer✔1000
lbs
When using a y-lanyard attached to your back d-ring, at what height should the connection to
your anchorage take place? - answer✔Shoulder level or above
A company's health, safety and environment policy should be a combination of labor regulation
and ? - answer✔Industry standards
10/30/2024 11:32 PM
Telecom Tower Technician 1 Exam
Questions And Answers 100% Pass
The basket slings on a gin pole perform what function? - answer✔Support part of the weight
and vertical forces
What is the minimum force that a work positioning system anchorage must be able to
withstand? - answer✔2 times the arresting force or 3,000 lbs
What term identifies a monopole component? - answer✔Base flange
All antennas are presumed active - answer✔True
When using bolts or u-bolts with a slotted hole present, what order are the components
installed? - answer✔Flat washer, lock washer, then nut
If you have a 16 ft ladder leaning against a building wall, how many feet from the wall does the
base need to be to provide the correct slope? - answer✔4 ft
For structural loading purposes the basket and bridle slings shall always be attached where? -
answer✔At a panel point around the leg
A hoist operator will respond to a stop signal from whom? - answer✔Any source
When calculating a fall distance using a 6 foot energy absorber, what is the maximum pull out
distance? - answer✔4 feet
How often shall all gin poles have a documented job inspection? - answer✔Daily
What do the letters LOTO stand for? - answer✔Lockout Tagout
What does a tag person do? - answer✔Applied pressure on the tag rope to controls the load
A capstan hoist is used on job sites for what purpose? - answer✔To raise and lower loads
, ©THEBRIGHT EXAM SOLUTIONS
10/30/2024 11:32 PM
When operating a Capstan Hoist, or tagging the load on the Capstan, it is important to wear
what? - answer✔Gloves
What does a Ground Fault Circuit Interrupter (GFCI) do? - answer✔Shuts off flow of electricity,
senses a short circuit, and prevents electricution
Which of the following is not a component of the gross load? - answer✔Tag force
What motion indicates retract the boom - answer✔Both fists in front of your body with your
thumbs pointed towards each other
What is the heel block used for? - answer✔To change the direction of the load, jump or tag line
from horizontal to vertical
An overhaul ball provides what function in the operations? - answer✔Provides weight allowing
the load line to treturn the ground
If the operator and signal person cannot see each other, what other way can they
communicate? - answer✔Radios
The three main components that make up a fall arrest system are - answer✔Anchorage, Full
body Harness, and connectors
What type of antenna is used to transmit signal from tower to tower? - answer✔Microwave
dish
For all power lines rated 50kv, the minimum clearance between the lines and any part of the
crane or load shall be - answer✔20 feet
All cranes must have a posted load chat visible from the operators station? - answer✔True
How often must a fire extinguisher be inspected by a qualified person? - answer✔Annually
What is a crown block? - answer✔An upper sheave assembly on top of a structure
When using a fall restraint system, what is the minimum anchorage allowed? - answer✔1000
lbs
When using a y-lanyard attached to your back d-ring, at what height should the connection to
your anchorage take place? - answer✔Shoulder level or above
A company's health, safety and environment policy should be a combination of labor regulation
and ? - answer✔Industry standards
