• ¿Documento equivocado? Cámbialo gratis
  • Escrito por estudiantes que aprobaron
  • Inmediatamente disponible después del pago
  • Leer en línea o como PDF
Vender
¿Dónde estudias?
Tu idioma
Document preview thumbnail
Vista previa 2 fuera de 11 páginas
Examen

Nicet Level 1 - Water Based Layout Practice Exam Questions And Answers

Document preview thumbnail
Vista previa 2 fuera de 11 páginas

Nicet Level 1 - Water Based Layout Practice Exam Questions And Answers Which of the following standards contain reqs. pertaining to the installation of underground piping? - answer -NFPA 13 & 24 (Both in Chapter 10) Which of the following should you inspect on an extension cord before each use? - answer -The grounding prong & the insulation for nicks, cuts, or damage ________ indicates a mandatory req. according to NFPA definitions. - answer -Shall. (Ref. NFPA 13 2016, Sec. 3.2.4.) 100 GPM is flowing through 100' of 1 1/4 in. Sch. 40 pipe. How many feet of 1 1/2 in. pipe will produce the same friction loss? - answer -Assume this is Schedule 40 pipe, C = 120. Use the Hazen-Williams formula to calculate the friction loss for the 1 ¼ in. pipe and the 1 ½ in. pipe. For 1 ¼ in. pipe (ID = 1.38): P friction loss = 4.52 x Q 1.85 c 1.85 x d 4.87 P friction loss = 4.52 x 100 1.85 120 1.85 x 1.38 4.87 P friction loss = 0.672 psi/ft For 1 ½ in. pipe (ID = 1.61): P friction loss = 4.52 x Q 1.85 c 1.85 x d 4.87 P friction loss = 4.52 x 100 1.85 120 1.85 x 1.61 4.87 P friction loss = 0.317 psi/ft Step #2: Determine the total friction loss for 100 gpm flowing through 100 ft. of 1 ¼ in. Schedule 40 black steel pipe: 100 ft. x 0.672 psi/ft = 67.2 psi Step #3: Determine the pipe length to produce the same friction loss in the 1 ½ in. pipe: y ft. x 0.317 psi/ft = 67.2 psi y = 67.2 ÷ 0.317 y = 212 ft. A basic contract: (choose all that apply) - answer -Contains the names of the parties involved, References the contract documents, Discusses the work that is to be done, and Discusses start and completion dates. Define both the constant, y, and the exponent ,z, for q in the Hazen-Williams friction loss formula shown Below: P = L x (y x Q^z) (c^1.85 x d^4.87) - answer -4.52, 1.85. Reference NFPA 13 2016 Section 23.4.2.1.1. A water flow test was conducted using 1 hydrant, flowing with two 2 1/2 inch outlets. Which is the approximate water flow rate, if the pitot reading was 15 psi. The hydrant outlet coefficiant is 0.8. - answer -The correct answer is 1156 gpm. Solution #12: Q 1 = 29.84 cd 2 √ P Q 1 = 29.84 x 0.8 x (2.5) 2 x √15 Q 1 = 577.8 gpm Both outlets are 2 ½ in., with the same outlet coefficient. Therefore, Q 1 = Q 2 The total flow rate is then: Q 1 + Q 2 = Q total Q total = 577.85 gpm + 577.85 gpm = 1155.70 gpm, round up to 1156 gpm Toggle hangers shall be permitted only for the support of pipe __________ inches or smaller in size under ceilings of hollow tile or metal lath and plaster. - answer -1 2/2 in. (ref. NFPA 13 2016 Sec. 9.2.1.1.2. While conducting a flow test, the chosen hydrant should be ______ - answer -As close to the property where the sprinkler system is being installed. (Ref, NFPA 13 Sec. A.24.2.2. or NFPA 291) What formula is used to determine the discharge coefficiant relating pressure and flow rate? - answer -K = Q / (Square root of P) What best describes a tree system? - answer -Cross mains and the branch lines are not tied together, providing only one path of water flow. Factors that define Occupancy Group Hazard 2 include: - answer -Quantity and combustibility of contents are moderate to high. Stockpiles of contents with moderate rates of heat release do not exceed 12 ft and stockpiles with high heat release do not exceed 8 ft (Ref NFPA 13 Sec. 5.3.2) If a cross main in a ________ pipe sprinkler system has three branch lines per bay, one intermediate hanger shall be permitted to be omitted, if a branch line hanger is installed on the starter peice. - answer -Steel. Reference NFPA 13 2016, Section 9.2.4.3. NFPA 13 specifies the depth of cover fro underground pipe of a minimum of 2 1/2 ft, 3 ft. under driveways and 4 ft. under railroads tracks. However, it must be at least 1ft. below the frost line. If the frost line is 2 1/2 ft, what is the minimum depth of cover under a driveway? - answer -3 ½ ft. Reference NFPA 13 2016, Section 10.4. If you are laying pipes under driveways, you must go down a minimum of 3 ft. However, you must be at least 1 ft. below the frost line. In this case that is 3 ½ ft.

Vista previa del contenido

Nicet Level 1 - Water Based Layout Practice
Exam Questions And Answers
Which of the following standards contain reqs. pertaining to the installation of
underground piping? - answer -NFPA 13 & 24 (Both in Chapter 10)

Which of the following should you inspect on an extension cord before each use? -
answer -The grounding prong & the insulation for nicks, cuts, or damage

________ indicates a mandatory req. according to NFPA definitions. - answer -Shall.

(Ref. NFPA 13 2016, Sec. 3.2.4.)

100 GPM is flowing through 100' of 1 1/4 in. Sch. 40 pipe. How many feet of 1 1/2 in.
pipe will produce the same friction loss? - answer -Assume this is Schedule 40 pipe, C =
120. Use the Hazen-Williams formula to calculate the friction loss for the 1 ¼ in. pipe
and the 1 ½ in. pipe.

For 1 ¼ in. pipe (ID = 1.38):


P friction loss = 4.52 x Q 1.85

c 1.85 x d 4.87


P friction loss = 4.52 x 100 1.85

120 1.85 x 1.38 4.87

P friction loss = 0.672 psi/ft


For 1 ½ in. pipe (ID = 1.61):


P friction loss = 4.52 x Q 1.85

c 1.85 x d 4.87

P friction loss = 4.52 x 100 1.85

120 1.85 x 1.61 4.87

, P friction loss = 0.317 psi/ft


Step #2: Determine the total friction loss for 100 gpm flowing through 100 ft. of 1 ¼ in.
Schedule 40 black steel pipe: 100 ft. x 0.672 psi/ft = 67.2 psi


Step #3: Determine the pipe length to produce the same friction loss in the 1 ½ in. pipe:

y ft. x 0.317 psi/ft = 67.2 psi


y = 67.2 ÷ 0.317


y = 212 ft.

A basic contract: (choose all that apply) - answer -Contains the names of the parties
involved, References the contract documents, Discusses the work that is to be done,
and Discusses start and completion dates.

Define both the constant, y, and the exponent ,z, for q in the Hazen-Williams friction
loss formula shown Below:

P = L x (y x Q^z)
(c^1.85 x d^4.87) - answer -4.52, 1.85.

Reference NFPA 13 2016 Section 23.4.2.1.1.

A water flow test was conducted using 1 hydrant, flowing with two 2 1/2 inch outlets.
Which is the approximate water flow rate, if the pitot reading was 15 psi. The hydrant
outlet coefficiant is 0.8. - answer -The correct answer is 1156 gpm.

Solution #12:


Q 1 = 29.84 cd 2 √ P


Q 1 = 29.84 x 0.8 x (2.5) 2 x √15


Q 1 = 577.8 gpm


Both outlets are 2 ½ in., with the same outlet coefficient. Therefore, Q 1 = Q 2

Información del documento

Subido en
30 de octubre de 2024
Número de páginas
11
Escrito en
2024/2025
Tipo
Examen
Contiene
Preguntas y respuestas
$10.49

¿Documento equivocado? Cámbialo gratis Dentro de los 14 días posteriores a la compra y antes de descargarlo, puedes elegir otro documento. Puedes gastar el importe de nuevo.
Escrito por estudiantes que aprobaron
Inmediatamente disponible después del pago
Leer en línea o como PDF

Seller avatar
Los indicadores de reputación están sujetos a la cantidad de artículos vendidos por una tarifa y las reseñas que ha recibido por esos documentos. Hay tres niveles: Bronce, Plata y Oro. Cuanto mayor reputación, más podrás confiar en la calidad del trabajo del vendedor.
TheExamMaestro
3.6
(18)
Vendido
159
Seguidores
5
Artículos
3828
Última venta
5 días hace




Por qué los estudiantes eligen Stuvia

Creado por compañeros estudiantes, verificado por reseñas

Calidad en la que puedes confiar: escrito por estudiantes que aprobaron y evaluado por otros que han usado estos resúmenes.

¿No estás satisfecho? Elige otro documento

¡No te preocupes! Puedes elegir directamente otro documento que se ajuste mejor a lo que buscas.

Paga como quieras, empieza a estudiar al instante

Sin suscripción, sin compromisos. Paga como estés acostumbrado con tarjeta de crédito y descarga tu documento PDF inmediatamente.

Student with book image

“Comprado, descargado y aprobado. Así de fácil puede ser.”

Alisha Student

Preguntas frecuentes