Which of the following indicators is used to denote the center of a circle? -
answer-+
What is the third color band on a resistor represents? - answer-The first and
second band represent the numerical value of the resistor, and the color of
the third band specify the power-of-ten multiplier. The fourth represents the
tolerance. The color bands are always read from left to right starting with the
side that has a band closer to the edge.
Identifying leader in the assembly process in order to routinely compare
one's processes and outputs to the leader is called - answer-Performance
matching
When energized a solenoid actuates upon which of the following objects: -
answer-Steel
Which statement best describes precision alignment? - answer-It corrects
any defects in the shaft
The most important factor for an engineer in selecting a project solution
should be - answer-Safety
Healthier staff, increased attendance and productivity, increased morale,
and reduced litigation risks are some of the advantages of adhering to what
regulations? - answer-OSHA
An international body of technical standards for various industries, designed
to promote international trade, engineering conformance, and most recently
environmental awareness is known of - answer-International organizations
for standardization
When determining the degree of acceptable risk in a project, an engineer
should always consider - answer-A cost/ risk / benefit analysis
Training and _____ may be given to comply with OSHA in the workplace -
answer-Teamwork
A good method of maintain a safe work area is to maintain a clean work
bench, attend safety meetings and - answer-Abide by safety signs
Performing engineering functions, ethical conduct is the responsibility of the
- answer-Individual engineer