ASE Test Prep - A5 Brakes - Practice
Test #1 Questions and Answers
A restricted brake hose on the right side. - -A vehicle pulls to the right after
the brake pedal is released. This could be caused by:
A. A restricted brake hose on the right side.
B. A faulty metering valve.
C. A cut master cylinder piston seal.
D. A restricted brake hose on the left side.
-Neither A nor B - -Technician A says that brake drag can be caused by a
seized star wheel adjuster. Technician B says that brake drag can be caused
by worn drums. Who is correct?
A. Technician A only
B. Technician B only
C. Technician A and B
D. Neither A nor B
-Brake light switch - -Which of the following would typically proved an input
to the ABS control module?
A. Power steering pressure switch
B. Pressure differential switch
C. PRNDL switch
D. Brake light switch
-Leaking master cylinder - -With the engine running, the brake pedal is low
and soft. Brake fluid level is low in the primary reservoir. Which of the
following would be the most likely cause?
A. Leaking master cylinder
B. A bypassing master cylinder
C. Stuck open vacuum check valve
D. Restricted vacuum
-Technician A only - -A brake line needs to be replaced. Technician A says a
new line should be installed using a double flare or ISO. Technician B says a
new section should be installed with compression fittings. Who is right?
A. Technician A only
B. Technician B only
C. Technician A and B
D. Neither A nor B
-The final check should be with a dial indicator - -A set of tapered roller
bearings are being serviced. Which of the following is true regarding the
tightening process?
Test #1 Questions and Answers
A restricted brake hose on the right side. - -A vehicle pulls to the right after
the brake pedal is released. This could be caused by:
A. A restricted brake hose on the right side.
B. A faulty metering valve.
C. A cut master cylinder piston seal.
D. A restricted brake hose on the left side.
-Neither A nor B - -Technician A says that brake drag can be caused by a
seized star wheel adjuster. Technician B says that brake drag can be caused
by worn drums. Who is correct?
A. Technician A only
B. Technician B only
C. Technician A and B
D. Neither A nor B
-Brake light switch - -Which of the following would typically proved an input
to the ABS control module?
A. Power steering pressure switch
B. Pressure differential switch
C. PRNDL switch
D. Brake light switch
-Leaking master cylinder - -With the engine running, the brake pedal is low
and soft. Brake fluid level is low in the primary reservoir. Which of the
following would be the most likely cause?
A. Leaking master cylinder
B. A bypassing master cylinder
C. Stuck open vacuum check valve
D. Restricted vacuum
-Technician A only - -A brake line needs to be replaced. Technician A says a
new line should be installed using a double flare or ISO. Technician B says a
new section should be installed with compression fittings. Who is right?
A. Technician A only
B. Technician B only
C. Technician A and B
D. Neither A nor B
-The final check should be with a dial indicator - -A set of tapered roller
bearings are being serviced. Which of the following is true regarding the
tightening process?
