ASE A4 Practice Test - ASE A4 Steering and Suspension Test Prep - Test 1(100% Correct!)

nician A says the power steering pressure switch sends a signal to the PCM to increase idle speed while performing parking maneuvers. Technician B says variable-assist steering provides maximum pressure at highway speeds. Who is correct? A. Technician A B. Technician B C. Both A and B D. Neith er A nor B Technician A - ANSWERTechnician A says the leaf spring's shackle should swivel as the vehicle travels over bumps. Technician B says that small cracks in the longest blade of a multi-leaf leak spring are acceptable. Who is correct? A. Technician A B. Technician B C. Both A and B D. Neither A nor B Wheel bearing. - ANSWERThe LEAST likely to result in memory steer is a binding: A. Ball joint. B. Steering gear. C. Upper strut mount. D. Wheel bearing. There is too much negative camber. - ANSWERThe inside tread of the tire in the illustration shows excessive wear. Which of the following is causing this uneven tire wear? A. There is too much positive camber. B. There is too much positive caster. C. There is too much negative camber. D. There is too much negative caster. Technician B - ANSWERTechnician A says worn idler arm does not affect a vehicle's total toe setting. Technician B says the center link is part of a parallelogram linkage system. Who is correct? A. Technician A B. Technician B C. Both A and B A nor B Both A and B - ANSWERDuring the visual inspection of a light truck, the technician notices the left rear left spring has a broken center bolt. Technician A says this will affect the vehicle's thrust angle. Technician B says an incorrect thrust angle will affect the centering of the steering wheel. Who is correct? A. Technician A B. Technician B C. Both A and B