MSSC - Quality Certification Verified Solutions

MSSC - Quality Certification Verified Solutions Which is NOT one of the steps used in the glass box method? ️rotate object in glass box The three standard views of an object are ______. ️top, front, right side What is the order of precedence of lines in a drawing? ️object, hidden, center What type of feature is parallel to the surface being dimensioned? ️dimension line A ______ dimension is described in inches per foot. ️shaft taper To establish on a drawing that 1/4 inch equals 1 inch, the designer would write ______. ️1/4 = 1 Section lines on a blueprint include _______. ️a surface that has been cut In a threaded fastener assembly what is designed to protect the threads? ️shank The minor diameter of a screw thread is measured at the ______. ️root of screw thread The minor diameter of a threaded fastener is ______. ️the major diameter minus the thread height How do you determine the grade of a bolt? ️number of lines on the head +2 indicates the grade A screw with National fine thread is represented on a drawing with what designation? ️NF Metals treated by ______ processes become soft. ️annealing A running fit is also called a(n) ______. ️sliding fit The term ______ refers to a physical portion of a part. ️feature A(n) _______ is a theoretically perfect line, point or pane that is located by a similar feature or part. ️datum GD&T _________________. ️allows certain tolerances on part features to be increased A feature control frame is not used to describe ______. ️measurements A common decimal inch rule graduation is in _______. ️50ths A scale typically found on a machinist rule is _______. ️1/16 Resolution is sometimes called ______. ️discrimination A common fractional inch rule graduation is in _______. ️32nds One inch is equal to _______. ️25.4mm A typical dial caliper can be used to measure dimensions to the nearest ________ inches. ️0.001