CR104B Vehicle Electrical and Mechanical Systems Test Questions and Answers 100% Solved

CR104B Vehicle Electrical and Mechanical Systems Test Questions and Answers 100% Solved If a blower motor does not run, a good first voltage check would be: at the hot side of the motor terminal. With a wire conductor, the heavier the gauge, the: less resistance it has. Current is being measured with the DVOM set to the 200 milliamp scale. The current flow increases to 2.5 amps. The meter will: blow a fuse. A normal working circuit with one load will read full source voltage: up until the load, and 0 volts after the load. Voltage in an automotive circuit: does not flow through the circuit. A voltmeter is connected at a connector located between the power window motor and ground. When the power window switch is closed, the meter reads 13 volts. A possible problem is a: break, or open, in the ground connection