Automatic Transmission ASE (A2) Questions With Correct Answers 2024/2025

Automatic Transmission ASE (A2) Questions With Correct Answers 2024/2025 A hydraulically controlled Automatic transmission shifts erratically (sometimes to soon, sometimes too late, and often shifts harshly) Tech A says that a misadjusted TV (throttle valve) cable could be the cause if equipped. Tech B says a defective TP (Throttle position) sensor could be the cause if the transmission is electronically shifted. Who is correct? A.) Tech A B.) Tech B C.) Both D.) Neither - ANS-C.) Both One transmission cooler line has been pinched in a minor accident. Tech A says that the transmission may overheat. Tech B says that premature wear may occur due to the lack of lube oil being returned from the cooler. Who is correct? A.) Tech A B.) Tech B C.) Both D.) Neither - ANS-C.) Both Two technicians are discussing what could be wrong with a hydraulically controlled automatic transmission/transaxle that does not shift out of first gear regardless of vehicle speed. Tech A says that a defective governor could be the cause. Tech B says that a weak pump could be the cause. Which Tech is correct? A.) Tech A B.) Tech B C.) Both D.) Neither - ANS-A.) Tech A Two technicians are discussing an electronically controlled automatic transmission that will not go into any forward gear or reverse. Tech A says that a defective computer could be the cause. Tech B says that an excessively worn torque convertor could be the cause. Which tech is correct? A.) Tech A B.) Tech B C.) Both D.) Neither - ANS-D.) Neither A vehicle equipped with an electronaicallt controlled transaxle stalls whenever slowing to a stop after being driven over 20 miles. Tech A says that on of the shift solenoids could be defective. Tech B says that a torque convertor clutch solenoid is likely to be defective. Who is correct? A.) Tech A B.) Tech B C.) Both D.) Neither - ANS-B.) Tech B An Automative transmission operates normally in reverse but the vehicle does not shift at all when moving forward. Tech A says that a defective torque convertor is the liekly cause, Tech B says a defective computer could be the cause. Who is correct?...