ASE A6 Test Prep (Electrical & Electronic Systems) Exam Questions And Answers

ASE A6 Test Prep (Electrical & Electronic Systems) Exam Questions And Answers Technician A only A technician connects one lead of a DMM (digital multimeter) to the positive (+) terminal of a battery and the other meter lead to the "B" terminal of the starter solenoid and then cranks the engine. During cranking, the voltmeter displays a reading of 878 mV. Technician A says this reading indicates the positive battery cable has very high resistance. Technician B says this reading indicates that the starter armature is defective. Who is right? Technician A only Technician B only Both Technicians A and B Neither Technician A nor B Replace the battery When performing a load test on a battery, a technician finds that the battery voltage drops below specifications. Which of the following is the MOST likely repair? a. Recharge the battery and return it to service b. Recharge the battery and retest it c. Replace the battery d. Replace the voltage regulator Technician A only Two technicians are describing battery charging. Technician A says to remove the surface charge from a recently charged battery and apply a 300-ampere load across the adapters for 15 seconds. Technician B says to remove the surface charge from batteries, which have been in storage. Who is right? Technician A only Technician B only Both Technicians A and B Neither Technician A nor B Technician A only