BMW Associate level ASE test

BMW Associate level ASE test a lifting pad must be in place to lift a BMW vehicle, T or F? - True A technician should consider which of the following questions for a quality control process after performing service work to a vehicle? Did I address all concerns? Did I top off all fluids and set tire pressure? Did I reset service lights? All of the above - All of the above According to MSDS warning symbols, the warning symbol with a skull and cross bones shown represents - Acute toxicity All BMW special tools are autoship to the dealer. True or False? - False All brand new BMW vehicles require a QC1 inspection. Tech A states that transport Mode should be deleted using ISTA. Tech B says that transport mode should be deleted using the transport mode switching device. - Both A and B All of the following are true concerning the Roundtable, EXCEPT : There are 12 shows each year. Each Roundtable has a bulletin describing the topics. The Roundtable is accessed through AIR. Each Roundtable has a quiz - The Roundtable is accessed through AIR. Battery voltage is not critical when performing a voltage drop on a circuit. True or False? - Flase BMW recommends replacing tire at least every 6 years what resource can you use to determine that the above statement is correct? - Owners Manual BMW special took can be used during an inspection to measure: Coolant level Coolant concentrate Brake pad thickness and tire thread depth Air pressure - Brake pad thickness and tire thread depth CPO inspections require a minimum tread depth of 3 mm, as measured from the lowest area in the tread. T or F? - False (from top of wear indicators) During a CPO inspection, a front brake pad measurement is taken of 4mm on the left inner pad and 7mm on the left outer pad. Technician A says the pads are within specifications. Technician B says the inner pad is at the minimum allowed specifications. Who is correct? - Neither A or B During a CPO inspection, all of the following items will need to be addressed before the CPO sale, EXCEPT: Mismatched tires Aftermarket windshield OEM brake pads with 4mm thickness of material remaining Wheel with a lateral runout of 1.2mm - A