NCCER study guide Module 1 Basic Safety
2024 with complete solution
Companies with strong safety cultures usually have lower _ .
turnover
Safety is a learned behavior and attitude. T/F
TRUE
Poor lighting, excessive noise, inadequate guards for moving parts are examples of _ _.
unsafe conditions
The activity that consists of breaking a job into its component task and then analyzing each step for
potential hazards is called _ _ _ .
job safety analysis
The measure of probability, consequences, and exposure related to an event is referred to as _ .
Risk
If there is a hole in the floor of a structure, the preferred method of protecting workers from falls is to
_______.
cover the opening and label the cover
.The D-ring or support point on a safety harness should be placed _ _ _ _ _ _ .
in the middle of the back
A personal fall arrest system should be inspected monthly by a _ _ .
competent person
Lanyards that have no shock-absorbing features are used for _ .
positioning
When placing a ladder against a platform or roof, the top of the ladder should extend above the point
where the ladder touches the platform or roof by at least _ _ _ .
3 feet (91 cm)
When performing overhead work on scaffolding, _ , _ _ , or _ must be applied as protective measures
to prevent objects from falling and striking a person below.
Toeboards, debris nets, canopies
When stacking materials such as bricks or blocks, do not stack materials beyond a _ _ _ _ _.
4:1 height-to-base ratio
Benching systems are prohibited in _ _ _ .
Type C Soils
2024 with complete solution
Companies with strong safety cultures usually have lower _ .
turnover
Safety is a learned behavior and attitude. T/F
TRUE
Poor lighting, excessive noise, inadequate guards for moving parts are examples of _ _.
unsafe conditions
The activity that consists of breaking a job into its component task and then analyzing each step for
potential hazards is called _ _ _ .
job safety analysis
The measure of probability, consequences, and exposure related to an event is referred to as _ .
Risk
If there is a hole in the floor of a structure, the preferred method of protecting workers from falls is to
_______.
cover the opening and label the cover
.The D-ring or support point on a safety harness should be placed _ _ _ _ _ _ .
in the middle of the back
A personal fall arrest system should be inspected monthly by a _ _ .
competent person
Lanyards that have no shock-absorbing features are used for _ .
positioning
When placing a ladder against a platform or roof, the top of the ladder should extend above the point
where the ladder touches the platform or roof by at least _ _ _ .
3 feet (91 cm)
When performing overhead work on scaffolding, _ , _ _ , or _ must be applied as protective measures
to prevent objects from falling and striking a person below.
Toeboards, debris nets, canopies
When stacking materials such as bricks or blocks, do not stack materials beyond a _ _ _ _ _.
4:1 height-to-base ratio
Benching systems are prohibited in _ _ _ .
Type C Soils
